Abstract:The apparatus of the ALICE experiment at CERN will be upgraded in 2017/18 during the second long shutdown of the LHC (LS2). A major motivation for this upgrade is to extend the physics reach for charmed and beauty particles down to low transverse momenta. This requires a substantial improvement of the spatial resolution and the data rate capability of the ALICE Inner Tracking System (ITS). To achieve this goal, the new ITS will be equipped with 50 um thin CMOS Pixel Sensors (CPS) covering either the 3 innermost layers or all the 7 layers of the detector. The CPS being developed for the ITS upgrade at IPHC (Strasbourg) is derived from the MIMOSA 28 sensor realised for the STAR-PXL at RHIC in a 0.35 um CMOS process. In order to satisfy the ITS upgrade requirements in terms of readout speed and radiation tolerance, a CMOS process with a reduced feature size and a high resistivity epitaxial layer should be exploited. In this respect, the charged particle detection performance and radiation hardness of the TowerJazz 0.18 um CMOS process were studied with the help of the first prototype chip MIMOSA 32. The beam tests performed with negative pions of 120 GeV/c at the CERN-SPS allowed to measure a signal-to-noise ratio (SNR) for the non-irradiated chip in the range between 22 and 32 depending on the pixel design. The chip irradiated with the combined dose of 1 MRad and 10^13 n_eq/cm^2 was observed to yield a SNR ranging between 11 and 23 for coolant temperatures varying from 15 C to 30 C. These SNR values were measured to result in particle detection efficiencies above 99.5% and 98% before and after irradiation respectively. These satisfactory results allow to validate the TowerJazz 0.18 um CMOS process for the ALICE ITS upgrade.

Data transmission architecture of the ALICE ITS3 stitched sensor prototype MOSAIX

Model and analysis of the data readout architecture for the ITS3 ALICE Inner Tracker System

Characterization results of MAPS digital prototypes for the ALICE ITS3

Applications of CMOS technology at the ALICE experiment

First measurements with monolithic active pixel test structures produced in a 65 nm CMOS process

ALICE ITS3: a bent stitched MAPS-based vertex detector

Development of the Readout Electronics for a MAPS-Based Beam Telescope

Design and characterization of novel monolithic pixel sensors for the ALICE ITS upgrade

Commissioning of the new ALICE Inner Tracking System

Digital Pixel Test Structures implemented in a 65 nm CMOS process

A 3.2-Gb/s Serial Link Transmitter in 0.18μm CMOS Technology for CMOS Monolithic Active Pixel Sensors Application

Charged particle detection performances of CMOS pixel sensors produced in a 0.18 um process with a high resistivity epitaxial layer

Upgrade of the ALICE Inner Tracking System

Upgrade of the Inner Tracking System of ALICE

Characterisation of analogue MAPS fabricated in 65 nm technology for the ALICE ITS3

The upgrade of the ALICE Inner Tracking System

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

A 4.25-Gbps serializer ASIC in 180 nm for the monolithic active pixel sensor of the NICA-MPD inner tracker system

Validation of the 65 nm TPSCo CMOS imaging technology for the ALICE ITS3