Abstract:Owing to their intrinsic (geometry dependent) radiation hardness, 3D pixel sensors are promising candidates for the innermost tracking layers of the forthcoming experiment upgrades at the Phase 2 High-Luminosity LHC (HL-LHC). To this purpose, extreme radiation hardness up to the expected maximum fluence of 2e16 <a class="link-external link-http" href="http://neq.cm" rel="external noopener nofollow">this http URL</a>-2 must come along with several technological improvements in a new generation of 3D pixels, i.e., increased pixel granularity (50x50 or 25x100 um2 cell size), thinner active region (~100 um), narrower columnar electrodes (~5 um diameter) with reduced inter-electrode spacing (~30 um), and very slim edges (~100 um). The fabrication of the first batch of these new 3D sensors was recently completed at FBK on Si-Si direct wafer bonded 6-inch substrates. Initial electrical test results, performed at wafer level on sensors and test structures, highlighted very promising performance, in good agreement with TCAD simulations: low leakage current (<1 pA/column), intrinsic breakdown voltage of more than 150 V, capacitance of about 50 fF/column, thus assessing the validity of the design approach. A large variety of pixel sensors compatible with both existing (e.g., ATLAS FEI4 and CMS PSI46) and future (e.g., RD53) read-out chips were fabricated, that were also electrically tested on wafer using a temporary metal layer patterned as strips shorting rows of pixels together. This allowed a statistically significant distribution of the relevant electrical quantities to be obtained, thus gaining insight into the impact of process-induced defects. A few 3D strip test structures were irradiated with X-rays, showing inter-strip resistance of at least several GOhm even after 50 Mrad(Si) dose, thus proving the p-spray robustness. We present the most important design and technological aspects, and results obtained from the initial investigations.

ALICE ITS 3: the first truly cylindrical inner tracker

ITS3: A truly cylindrical inner tracker for ALICE

ALICE ITS3: how to integrate a large dimension MAPS sensor in a bent configuration detector

Characterization results of MAPS digital prototypes for the ALICE ITS3

Applications of CMOS technology at the ALICE experiment

ALICE ITS3: a bent stitched MAPS-based vertex detector

The ITS3 detector and physics reach of the LS3 ALICE Upgrade

First measurements with monolithic active pixel test structures produced in a 65 nm CMOS process

The upgrade of the ALICE Inner Tracking System

First demonstration of in-beam performance of bent Monolithic Active Pixel Sensors

The CMS Silicon Strip Tracker - Overview and Status

Upgrade of the ALICE Inner Tracking System

Design and characterization of novel monolithic pixel sensors for the ALICE ITS upgrade

Upgrade of the Inner Tracking System of ALICE

A Full Functional Monolithic Active Pixel Sensor Prototype for the CEPC Vertex Detector

First Production of New Thin 3D Sensors for HL-LHC at FBK

Characterisation of analogue MAPS fabricated in 65 nm technology for the ALICE ITS3

Heavy Flavour measurements in Pb$-$Pb collisions with the upgraded ALICE Inner Tracking System

Upgrading the Inner Tracking System and the Time Projection Chamber of ALICE