Abstract:The study confirmed that the frictional behaviour of paper‐based materials is influenced by surface topography rather than surface roughness of plates. There was no clear correlation between the surface roughness of materials, fibre orientation, calculated total surface energy and friction coefficient. However, possible correlation between the dispersion components of the surface energy and kinetic friction were observed. Thermal camera analysis proved that material stickiness on forming tube of VFFS machine can occur due to high sliding speed and contact pressure. This study evaluated the frictional behaviour of flexible polymer‐coated and dispersion‐coated materials used in vertical form–fill–seal (VFFS) machines. A laboratory‐scale friction measurement device was developed to investigate the relationship between different surface topographies, roughness and frictional properties. Furthermore, surface roughness, contact angle and surface energy of the material were analysed and a microscopic analysis was performed to further understand the effect of material properties on friction. Thermal camera analysis was performed to measure the temperature changes within the material during the film‐transport stage of the VFFS machine. The friction measurement results indicated that the sliding direction did not affect the static and kinetic coefficients of friction. The significant influence of friction on the surface topography of the plate (forming shoulder and tube) was particularly evident. Some materials experienced the stick–slip phenomenon during sliding, depending on the surface type. Teflon tape, which is commonly used in the forming tubes of VFFS machines, exhibited the lowest coefficient of friction. Thermal camera analysis revealed that polymer‐coated paper materials generated more heat than dispersion‐coated papers during VFFS trials and thermoplastic films generated the least heat. No clear relationship between the surface roughness of the paper, fibre orientation, surface energy and friction coefficient was noted. Furthermore, paper‐based materials exhibited a higher coefficient of friction, which is possibly related to the dispersion components of surface energy. The findings of this study provide additional knowledge for designing the forming tube, shoulder geometry and surface plate to minimize the occurrence of defects, such as wrinkles, in paper‐based packages.

Role of blank moisturisation in press forming of paperboard

Study on Rheological Characteristic Applied in the Process of Hot-pressing for Particleboard

The effects of pretreatment and coating on the formability of extrusion‐coated multilayer paperboard–plastic composites

Lignin Inter-Diffusion Underlying Improved Mechanical Performance of Hot-Pressed Paper Webs

Influence of density and chemical additives on paper mechanical properties

Foam-laid extensible paper for improved extensibility and press-forming performance

Evaluation of Frictional Influence and Thermal Analysis of Flexible Paper‐Based Materials Used in the Vertical Form–Fill–Seal Process: An Experimental Study

Effect of Raw Material and Process Conditions During the Dry Forming of CTMP Fibers for Molded Pulp Products

Enhancing the strength of tissue paper through pulp fractionation and stratified forming

Effect of filler additions on pilot-scale extrusion coating of paperboard with PLA-based blends

Deep-drawing of paper and paperboard: The role of material properties

Heterogeneity characterization of commercial structural papers

The influence of the composition of pulp and the number of layers on the strength properties of multi-layer papers intended for the production of corrugated paperboard

Novel Forming Shoulder for Coated Paper‐Based Materials With Improved Convertibility and Minimum Wrinkles for Use in Vertical Form, Fill and Seal Machines

Effect of restrained versus free drying on hygro-expansion of hardwood and softwood fibers and paper handsheet

Impact of different coating processes of microfibrillated cellulose on the mechanical and barrier properties of paper

Extending the limits of using chemithermomechanical pulp by combining lignin microparticles and hot-pressing technology

The effect of chemical composition on microfibrillar cellulose films from wood pulps: water interactions and physical properties for packaging applications

Preparation of Hot-Pressed Wheat Straw Board by Self-Adhesive Process: Effects of Raw Material Sizes and Acid/Alkali Pretreatment

Microstructure and mechanical properties of free and restrained dried paper: a comprehensive investigation

Effect of cellulose micro/nanofibrils and carboxylated styrene butadiene rubber coating on sack kraft paper