Abstract:Scanning probe microscopy was used to simultaneously determine the molecular chain structure and intrinsic mechanical properties, including anisotropic elastic modulus and friction, for lamellae of highly oriented high-density polyethylene (HDPE) obtained by the melt-drawn method. The molecular-scale image of the highly oriented lamellae by friction force microscopy (FFM) clearly shows that the molecular chains are aligned parallel to the drawing direction, and the periodicities along and perpendicular to the drawing direction are 0.26 and 0.50 nm, respectively. The results indicate that the exposed planes of the lamellae resulting from the melt-drawn method are (200), which is consistent with results of transmission electron microscopy and electron diffraction. Because of the high degree of anisotropy in the sample, coming from alignment of the molecular chains along the drawing direction, the measured friction force, F, determined by FFM is strongly dependent on the angle, theta, between the scanning direction and the chain axis. The force increases as theta is increased from 0 degrees (i.e., parallel to the chain axis) to 90 degrees (i.e., perpendicular to the chain axis). The structural anisotropy was also found to strongly influence the measurements of the transverse chain modulus of the polymer by the nanoindentation technique. The measured value of 13.8 GPa with transverse modulus was larger than the value 4.3 GPa determined by wide-angle X-ray diffraction, which we attributed to anisotropic deformation of the lamellae during nanoindentation measurements that was not accounted for by the elastic treatment we adopted from Oliver and Pharr. The present approach using scanning probe microscopy has the advantage that direct correlations between the nanostructure, nanotribology, and nanomechanical properties of oriented samples can be determined simultaneously and simply.

Microstructure and mechanical properties of free and restrained dried paper: a comprehensive investigation

Effect of restrained versus free drying on hygro-expansion of hardwood and softwood fibers and paper handsheet

Study on the Moisture Content and Tensile Properties of Corn Straw

Transient hygro- and hydro-expansion of freely and restrained dried paper: the fiber-network coupling

Humidity Influence on Mechanics and Failure of Paper Materials: Joint Numerical and Experimental Study on Fiber and Fiber Network Scale

Full-field, quasi-3D hygroscopic characterization of paper inter-fiber bonds

Influence of fiber composition and drying conditions on the bending stiffness of paper

AFM-based low frequency viscoelastic characterization of wood pulp fibers at different relative humidity

Nanostructure and Mechanical Measurement of Highly Oriented Lamellae of Melt-Drawn HDPE by Scanning Probe Microscopy

Influence of density and chemical additives on paper mechanical properties

Study on free shrinkage and rheological characteristics of Eucalyptus urophylla ×E. grandis during conventional drying

The role of fibre bonds in permanent curl of paper and how it is affected by crosslinking

Drying of paper: A review 2000–2018

Air-drying of 3D printed part made of ligno-cellulosic fibres: 3D real-time monitoring combining sub-minute laboratory X-ray microtomography and digital volume correlation

Estimation of the in-situ elastic constants of wood pulp fibers in freely dried paper via AFM experiments

The effect of soil fabric on shrinkage behaviour and microstructure evolution of soft soils upon drying

XRD investigation of mechanical properties of cellulose microfibrils in S1 and S3 layers of thermally modified wood under tensile loading

Mapping humidity-dependent mechanical properties of a single cellulose fibre

Study of self-heating and local strain rate in polyamide-6 and short fibre glass/polyamide-6 under tension through synchronised full-field strain and temperature measurements

Influence of drying conditions on the stress and weight development of capillary suspensions

Initial wet web strength of paper