Abstract:Comparator is a connection between the analog and digital worlds [1] –[5]. A low-noise and low-power comparator is important in many applications, such as SAR ADC. Traditionally, such a comparator is realized as the Strong-Arm (SA) latch. It has the advantage of fullydynamic operation and embedded pre-amplifier. However, its preamplifier gain is as low as 4 5, which increases the input-referred noise and offset. In recent years, there are many efforts to design a more efficient dynamic comparator. Both [1] and [2] improve the dynamic-bias comparator of [3] that is based on the subthreshold-biased input transistors for large $\mathrm{g}_{\mathrm{m}} / \mathrm{l}_{\mathrm{D}}$. Among them, [1] uses a floating inverter amplifier (FIA) as the pre-amplifier. This pre-amplifier has a large voltage gain of approximately 30, which suppresses the noise and offset effectively. It realizes a 2-times current reuse, improving the energy efficiency. However, the energy efficiency can hardly be improved further, since it is independent of the device sizes. The current reuse is also limited to 2 times, which is far away from the maximum possible times (for example, 4 times in this work). [2] uses a charge pump and capacitive positive feedback for faster speed but at the cost of increased power. Its noise is also as large as $174 \mu \mathrm{V} \mathrm{rms}$, which is 3.8 times larger than [1].

A 0.9 V high‐speed dynamic bias latch‐type comparator employing a voltage‐controlled delay line

A Threshold Control Technique for CMOS Comparator Design

A Low Power Continuous Time Hysteresis Comparator with an Average Current Consumption of 614na at 1.5 Voltage

A Low-Power Low-Noise Dynamic Comparator with Latch-Embedding Floating Amplifier

High Speed, Low Power Dynamic Comparator with Dynamic Biasing in Pre-amplifier Phase

A novel low-offset dynamic comparator for high-speed low-voltage pipeline ADC

Design and Analysis of Low Power and High-Speed Dynamic Comparator with Transconductance Enhanced in Latching Stage for ADC Application

A low power and high speed 45 nm CMOS dynamic comparator with low offset

An Energy-Efficient Comparator with Dynamic Floating Inverter Pre-Amplifier

A Three-Stage Comparator with High Speed and Low Power

A 0.69-Noise-efficiency-factor 4 X-Current-reuse Dynamic Comparator with A Stacking FIA

A Low Noise High Speed Dynamic Comparator Insensitive to PVT and Common-mode Input

A 0.41ns CLK-OUT Delay, 0.22mvrms Input-Referred Noise CMOS Integration Dynamic Comparator with Flipping Capacitor for Charge Reuse

A precise dynamic CMOS comparator

A Novel Low-Offset Dynamic Comparator for Sub-1-v Pipeline ADCs

A high‐speed and power efficient CMOS dynamic comparator for data converter circuits

High-speed cascode cross-coupled CMOS dynamic comparator with auxiliary inverter pair

A high-efficient dynamic comparator with low-offset in weak inversion region

Speed enhancement and kickback noise reduction in single-stage latched comparator improved for high-speed and low-noise analogue-to-digital converters

A 0.2-Mv 20-Mhz 600-Μw Comparator

Design of a Strong-Arm Dynamic-Latch based comparator with high speed, low power and low offset for SAR-ADC