Abstract:In an atomic vapor laser isotope separation process, the required isotope atoms are ionized selectively by a pulsed laser with a specific narrow line width, and then the produced isotope ions are extracted to the collected plates under an externally applied electromagnetic field. In the whole ion separation process, the ion extraction sub-process is one of the most important physical processes. Previous studies have shown that the key parameters of the laser-induced plasma, e.g., the initial electron number density and temperature, have a significant influence on the ion extraction features. In an actual isotope separation process, a specifically designed laser is necessary to produce the required isotope ions, which, however, leads the whole facility to have a very complicated structure, high capital cost, and especially, very narrow window of the key plasma parameters. These will, to some extent, limit a more in-depth investigation of the influences of the key plasma parameters on the ion extraction characteristics. In this paper, an ion extraction platform (ion extraction simulation experimental platform-2015, IEX-2015) is developed on the basis of a gas discharge plasma jet driven by a kilo-hertz high-voltage power supply. And an argon plasma "collisional-radiative" model is established to measure the electron temperature and number density in the plasma jet region. The experimental results show that the power input and driving frequency of the power supply and the argon mass flow rate can all affect the electron temperature and electron number density. The measured variation ranges of the electron number density and temperature are 10(9)-10(11) cm(-3) and 1.7-2.8 eV, respectively, under a chamber pressure on the order of 10(-2) Pa, which are close to the parameter levels in the actual ion extraction process. Subsequently, the preliminary ion extraction experiments are conducted under different extraction conditions including different externally applied voltages, different electrode distances and different plasma densities. The experimental results are also qualitatively consistent with those in an actual ion extraction process. The preceding preliminary experimental results show that it is feasible to conduct the ion extraction simulation study on IEX-2015. This is very helpful for systematically studying the ion extraction characteristics under different operating conditions in our future research.

Increasing the Efficiency of Plasma Mass Separation by Optimizing the Electric Potential

Effect of Electron-to-ion Mass Ratio on Radial Electric Field Generation in Tokamak

Harnessing mass differential confinement effects in magnetized rotating plasmas to address new separation needs

Electrode Geometry Optimization in Wire-Plate Electrostatic Precipitator and Its Impact on Collection Efficiency

ExB flows for high-throughput plasma mass separation

Effect of ion acceleration on a plasma potential profile formed in the expander of a mirror trap

Simulating the trajectory of conductive particles in positive high-voltage electrostatic separators and optimizing parameters

Performance improvement of particle-in-cell method for numerical modelling of open magnetic system

Generation of low-energy abundant electron energy probability functions using a magnetized plasma source

Physical Characteristics of Ion Extraction Simulation System Based on Gas Discharge Plasma Jet

Plasma For-Injector of Separable Material Based on the Beam-Plasma Discharge for Ion-Atomic Separation Technologies. Conception

Efficient magnetic fields for supporting toroidal plasmas

Effects of Electron Temperature on the Ion Extraction Characteristics in a Decaying Plasma Confined Between Two Parallel Plates

Effect of Surface Inhomogeneity of Ion-Exchange Membranes on the Mass Transfer Efficiency in Pulsed Electric Field Modes

Improving accuracy of field work calculations for the analysis of the electron acceleration mechanisms in near-critical density plasma

The Strong Enhancement of Electron-Impact Ionization Processes in Dense Plasma by Transient Spatial Localization

Experimental study on plasma characteristics in the extraction region of a high-power RF negative ion source based on electrostatic probe

Large tangential electric fields in plasmas close to temperature screening

Numerical simulation of magnetic field influence on plasma and electron extraction of electron cyclotron resonance neutralizer

Experimental investigation of an electronegative cylindrical capacitively coupled geometrically asymmetric plasma discharge with an axisymmetric magnetic field

Experimental and Theoretical Study of the Manifestation of the Major Background Singly Charged ArM+ Argide Ions in Inductively Coupled Plasma Mass Spectrometry