Abstract:It has been proven that ultrasound irradiation can enhance the rate of heat transfer processes. The objective of this work was to study the heat transfer phenomenon, mainly the heat exchange at the surface, as affected by ultrasound irradiation around a stationary copper sphere (k=386Wm−1K−1, Cp=384Jkg−1K−1, ρ=8660kgm−3) during cooling. The sphere (0.01m in diameter) was immersed in an ethylene glycol–water mixture (−10°C) in an ultrasonic cooling system that included a refrigerated circulator, a flow meter, an ultrasound generator and an ultrasonic bath. The temperature of the sphere was recorded using a data logger equipped with a T-type thermocouple in the center of the sphere. The temperature of the cooling medium was also monitored by four thermocouples situated at different places in the bath. The sphere was located at different positions (0.02, 0.04 and 0.06m) above the transducer surface of the bath calculated considering the center of the sphere as the center of the reference system and was exposed to different intensities of ultrasound (0, 120, 190, 450, 890, 1800, 2800, 3400 and 4100Wm−2) during cooling. The frequency of the ultrasound was 25kHz. It was demonstrated that ultrasound irradiation can increase the rate of heat transfer significantly, resulting in considerably shorter cooling times. Higher intensities caused higher cooling rates, and Nu values were increased from about 23–27 to 25–108 depending on the intensity of ultrasound and the position of the sphere. However, high intensities of ultrasound led to the generation of heat at the surface of the sphere, thus limiting the lowest final temperature achieved. An analytical solution was developed considering the heat generation and was fitted to the experimental data with R2 values in the range of 0.910–0.998. Visual observations revealed that both cavitation and acoustic streaming were important for heat transfer phenomenon. Cavitation clouds at the surface of the sphere were the main cause of heating effect. The results showed that closer distances to the transducer surface showed higher cooling rates. On the other hand, despite having a bigger distance from the transducer, when the sphere was located close to the gas–liquid interface the enhancement factor of heat transfer was higher. Ultrasound irradiation showed promising effect for the enhancement of convective heat transfer rate during immersion cooling. More investigations are required to demonstrate the behavior of ultrasound assisted heat transfer and resolve the proper way of the application of ultrasound to assist the cooling and/or freezing processes.

Heat transfer enhancement using 2MHz ultrasound

Heat transfer enhancement of water flow over a heating flat plate using 20 kHz ultrasonic waves irradiated from submerged horn-type transducer

Saturated Boiling Heat Transfer under Ultrasound

Heat transfer mechanism of nucleated bubbles on vertical heating surface induced by 2.4 MHz waves in HFE-7100 liquid

Experimental study of heat transfer performance in rectangular microchannels enhanced by ultrasound

Ultrasound-assisted enhancement of heat transfer in immersed coil heat exchangers: Effects of acoustic intensity and ambient fluid properties

Flow boiling heat transfer enhancement under ultrasound field in minichannel heat sinks

Experimental Study on Heat Transfer Enhancement of Water-water Shell-and-Tube Heat Exchanger Assisted by Power Ultrasonic

Experimental investigation of flow boiling heat transfer enhancement under ultrasound fields in a minichannel heat sink

Experimental study of the effects of ultrasound on the heat transfer enhancement in a 3D-printed minichannel heat sink

Heat Transfer Enhancement by a Focused Ultrasound Field

Experimental study on thermal and friction characteristics of liquid flow across a heating cylinders under low-frequency ultrasound

Heat Transfer in a Liquid under Focused Ultrasonic Field

Characterization of heat transfer and friction loss of water turbulent flow in a narrow rectangular duct under 25-40 kHz ultrasonic waves

Ultrahigh heat transfer enhancement using nano-porous layer

Numerical Modeling of Particle to Fluid Heat Transfer During Ultrasound Assisted Immersion Cooling

The Effect of Ultrasound Irradiation on the Convective Heat Transfer Rate During Immersion Cooling of a Stationary Sphere.

Experimental Study of the Ultrasonic Effect on Heat Transfer Inside A Horizontal Mini-Tube in the Laminar Region

Consideration of Heat Transfer Enhancement Mechanism Using Nano- and Micro-Scale Porous Layer

Improvement of ultrasonic heat transfer enhancement using acoustical focusing and resonance properties

Experimental investigation of ultrasonic effect on natural and forced heat transfer in heat sinks