Abstract:Further development of capillary electrochromatography (CEC) is to some extent restricted by column technology. Packed capillary columns are most commonly used in CEC because of higher sample capacity and higher sensitivity than open tubular columns, and better reproducibility and uniformity than monolithic columns. Fritting is the core component for the fabrication of packed capillary columns. Therefore various fritting technologies attract continuous attention from analytical community. A convenient fritting method was developed in this study. In contrast to the reported single-particle fritting, this method applies a multi-particle fritting technology to hold stationary phase in capillary columns. Several large porous particles smaller than the column internal diameter were tapped in and immobilized in inlet and outlet of the packing material bed due to direct and indirect keystone effect. Except the smallest permeability by the sintered frit and the lowest breaking pressure by the single-particle frit, EOF mobility and peak dispersion of the multi-particle frit were at the same levels with the formers. In addition, all the three frits avoided bubble formation. It demonstrated that the multi-particle frits met the general requirements of permeability, mechanical resistance and efficiency for packing capillary microcolumns as well as the sintered frits and the single-particle frits. Thus, peak efficiency around 4.3 μm plate height (approximately 232,560 plates per meter) was obtained by multi-particle fritted capillary columns with electrokinetic packing, compared to 6.5 μm plate height by single-particle fritted columns with slurry pressure packing. In particular, the multi-particle fritting was simpler, faster, and more reproducible than the sintered fritting, and the multi-particle fritting was suitable to pack capillary columns of various capillary bore sizes owing to rich commercial resources of fritting particles of various diameters. Multi-particle fritted columns offered satisfactory run-to-run and column-to-column reproducibilities for retention factor, plate height and peak area (precisions of 4.1-9.3% for 10 replicated columns, and precisions of 0.9-3.1% for 30 replicated trials). They also had consistent CEC performance (differences of 1.1-3.9% between the first and 31 st day) during a lifetime more than one month. Application examples in packing capillary columns of 75 and 100 μm i.d. and CEC analysis of sixteen polycyclic aromatic hydrocarbons prove the diversity and reliability of the multi-particle fritting in column technology.

Incorporation of zeolitic imidazolate framework (ZIF-8)-derived nanoporous carbons in methacrylate polymeric monoliths for capillary electrochromatography

Metal organic framework-organic polymer monolith stationary phases for capillary electrochromatography and nano-liquid chromatography

A metal organic framework-functionalized monolithic column for enantioseparation of six basic chiral drugs by capillary electrochromatography

Preparation and Evaluation of a Series of Reversed‐Phase Monolithic Columns for Capillary Electrochromatography

Novel Hybrid Organic-Inorganic Monolithic Column Containing Mesoporous Nanoparticles for Capillary Electrochromatography

Preparation and evaluation of ultra-long open-tubular capillary columns modified with zeolitic imidazolate framework-8 incorporated polymeric porous layer for liquid chromatography

Preparation and characterization of inorganic silica-organic polymer mixture based C16 capillary monolithic column

Fabrication of single-walled carbon nanohorns incorporated a monolithic column for capillary electrochromatography.

A Strong Inorganic Acid-Initiated Methacrylate Polymerization Strategy for Room Temperature Preparation of Monolithic Columns for Capillary Electrochromatography

Preparation and Characterization of C16 Monolithic Columns for Capillary Electrochromatography.

Preparation and Porous Property of C-14-Monolithic Column for Capillary Electrochromatography

Preparation and Evaluation of Organic-Inorganic Hybrid Silica-Based Monolithic Columns for Capillary Electrochromatography

Preparation Of A Novel Zwitterionic Hybrid Monolith Column With Incorporated Fumed Silica Nanoparticle And Its Application In Pressurized Capillary Electrochromatography

Multi-particle Frits for Packed Capillary Columns in Electrochromatographic Use

Metal-organic Framework ZIF-8 Nanocrystals As Pseudostationary Phase for Capillary Electrokinetic Chromatography.

Hybrid monolithic columns with nanoparticles incorporated for capillary electrochromatography.

Preparation and Characterization of Molecularly Imprinted Monolithic Column Based on 4-Hydroxybenzoic Acid for the Molecular Recognition in Capillary Electrochromatography

Preparation and characterization of monolithic columns for capillary electrochromatography with weak electroosmotic flow

In Situ Synthesis of Homochiral Metal-Organic Framework in Capillary Column for Capillary Electrochromatography Enantioseparation.

In Situ Rapid Preparation of Homochiral Metal-Organic Framework Coated Column for Open Tubular Capillary Electrochromatography.

Monolithic Columns with Mixed Modes of Reversed-Phase and Anion-Exchange Stationary Phase for Capillary Electrochromatography