Abstract:The dividing‐wall column (DWC) stands as an energy‐efficient distillation technology designed to efficiently separate ternary systems into their pure components within a single column. Despite its efficiency, integrating two towers into a DWC poses challenges in controllability. Published studies have focused on developing controllers for disturbance rejection but have not addressed the issue of servo control. Addressing this, our study proposes a servo controller problem and a methodical approach to strategically select controlled variables that undergo consecutive set point step changes, aiming to track the purity of key products obtained from the DWC. To achieve this goal, we developed a dynamic model specifically tailored to the DWC. Determining the design parameters involved employing a genetic algorithm optimization technique, minimizing the total annual cost. Subsequently, we implemented three servo parallel proportional‐integral (PI) feedback controllers for three distinct product streams. The fine‐tuning of their controller gain and reset time is carried out by minimizing the integrated square error while adhering to valve opening constraints. Our investigation revealed a limitation: the introduction of simultaneous step changes in all three controlled variables proved unfeasible with the three active PI controllers. As an alternative, our findings recommend prioritizing two variables: the lightest (distillate) and heaviest (bottom) key components, alongside the middle component (side stream) and either the lightest or heaviest key component. This research underscores the complexities of implementing step changes in multiple controlled variables within a DWC, offering insights into optimal control strategies for enhancing the efficiency of this innovative distillation technology.

Design and hydraulic study of double‐partition dividing‐wall column

A Study on Increasing Separation Efficiency of an Industrial, Compound Distillation Column

CFD modeling of double-partition divided-wall column for mass transfer characteristics

Exploring the Essence of Three-Phase Packed Distillation: Substantial Mass Transfer Computation

Numerical Simulations Of Fluid Dynamics And Mixing In A Large Shallow Bubble Column: Effects Of The Sparging Pipe Allocations For Multiple-Pipe Gas Distributors

Design, optimization, and industrial-scale experimental study of a high-efficiency dividing wall column

A Separation Column for Liquid Mixture Based on Phase Transform: Experiment and Simulation

Energy, exergy, economic, and environmental analysis of a novel liquid-only transfer dividing wall column with vapor recompression

Design and Control of Extractive Dividing Wall Column for Separating Dipropyl Ether/1-Propyl Alcohol Mixture

Dividing‐wall column for separating wide boiling mixture: Optimal design and servo control strategy

Computational Fluid Dynamics Simulation of Three-Dimensional Liquid Flow and Mass Transfer on Distillation Column Trays

Design and optimization of heat integrated dividing wall columns for improved debutanizing and deisobutanizing fractionation of NGL

Experimental study of two phase flow characteristics on the dual-flow tray

A Simple Screening Method for Distillation Sequence of Thermally Coupled Dividing Wall Column: Distillation Sequence Morphological Analysis Method(DSMAM)

Numerical Simulation of Multiphase Flow in Combined Guided Valve Tray of Distillation Column

Computational study for mass transfer on commercial multi-pass trays

3D-CFD Simulation of Liquid–Liquid Two-Phase Flow in A Pilot-Plant Scale Annular Pulsed Disc and Doughnut Column

Optimal design of extractive dividing-wall column using an efficient equation-oriented approach

Experimental research and numerical analysis for effect of drainage structure on separation performance and the "blockage" of fluid in nozzle

Experimental study of two-phase flow inside finned-tubes separator using 3-D-PDA

Graphical Design of Integrated Reaction and Distillation in Dividing Wall Columns