Abstract:The adoption of the brushless DC motor in the electric drive vehicle industry continues to grow due to its robustness and ability to meet torque–speed requirements. This work presents the implementation of a fault-tolerant control (FTC) for a BLDC motor designed for electric vehicles. This paper focuses on studying the defect in the Ha sensor and its signal reconstruction, assuming possible cases, but the same principle is applied to the other two sensors (Hb and Hc ). In this case, the fault diagnosis allows for the correction and reconstruction of the signal in order to compel the system to work despite the presence of a fault. Indeed, several robust control systems are used within the work to regulate the speed of the motor properly, such as control via fuzzy logic and control via a neural network. This paper presents three BLDC control configurations for EVs, PID, fuzzy logic (FL), and an artificial neural network (ANN), discusses the pros and cons, and develops corresponding mathematical models to enhance a fault-tolerant control strategy which is analyzed and studied using MATLAB-based simulations (by discussing the two cases, the steady state and the transient state), allowing for a novel design based on the analytical models developed. The results obtained from the simulation of this system improved the speed controlled by the neural network compared to the fuzzy logic controller. At the same time, the sensor failure had no effect on the system's operation due to the efficiency of the FTC control.

Fault diagnosis and fault-tolerant finite control set-model predictive control of a multiphase voltage-source inverter supplying BLDC motor

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

Fault-Tolerant Control Strategy for Hall Sensors in BLDC Motor Drive for Electric Vehicle Applications

A Fault-Tolerant Direct Torque Control Strategy for A Brushless Dc Motor Driven by A Single Sided Matrix Converter

Fault-Tolerant Control Method for Five-Phase PMSM with High Control Performance and Low Computational Burden

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Fault Tolerant Control of Harmonic Injected Nine-Phase Flux Switching Permanent Magnet Motor Drive System

Prediction Error Analysis of Finite-Control-Set Model Predictive Current Control for IPMSMs

Fault-Tolerant Control of Dual-Three-Phase PMSM under Open-Phase Fault Based on Two-Individual Current Control

Simplified Fault-Tolerant Model Predictive Control for a Five-Phase Permanent-Magnet Motor with Reduced Computation Burden

Fault‐tolerant control of current residual vector three‐phase four‐switch motor drive system based on MLD model

A Generalized Open-Circuit Fault-Tolerant Control Strategy for FOC and DTC of Five-Phase Fault-Tolerant Permanent-Magnet Motor

Fault-Tolerant Technique against Current Sensors for Model Predictive Control of Induction Motor Drives

An Embedded Fault-Tolerant Control Method for Single Open-Switch Faults in Standard PMSM Drives

Fault-Tolerant Operation of a Six-Phase Permanent Magnet Synchronous Hub Motor Based on Model Predictive Current Control With Virtual Voltage Vectors

Dual-Vector-Based Predictive Torque Control for Fault-Tolerant Inverter-Fed Induction Motor Drives With Adaptive Switching Instant

Open-Circuit Fault-Tolerant Control of a Six-Phase Asymmetric Permanent Magnet Synchronous Motor Drive System

Generalized Fault-Tolerant Model Predictive Control of Five-Phase PMSM Drives Under Single/Two Open-Switch Faults

Model Predictive Current Control of Nine-Switch Inverter-Fed Six-Phase Induction Motor Drives Under Healthy and Fault Scenarios

Fuzzy Logic Vector Control design for fault-tolerant control of a 15-phase induction machine

Enhanced Natural Fault-Tolerant Model Predictive Current Control in Nine-Phase Motor Drives Under Open-Phase Faults