Abstract:Refractory high entropy alloys (RHEAs), which comprise high-melting-point refractory elements, have been regarded as potential candidates that can substitute nickel-based superalloys used in high-temperature applications. This study investigated the microstructure, hardness, corrosion, and oxidation behavior of the TiNbTaVW RHEA compared with commercial-grade IN718 alloy. The equiatomic TiNbTaVW RHEA was produced using an arc melting furnace. The microstructure of the as-cast RHEA consisted of a body-centered cubic solid-solution phase with a dendritic structure corresponding to the empirical phase prediction. The RHEA exhibited a higher hardness of 522 ± 10 HV than the IN718 alloy with 301 ± 14 HV. The higher hardness is due to solid-solution strengthening and grain refinement. The RHEA had a lower corrosion rate in 3.5 wt% NaCl (0.0003 mm/yr) and 1 M H 2 SO 4 (0.0009 mm/yr) than the commercial IN718 alloy (0.054 mm/yr and 1.12 mm/yr, respectively). At 850 °C after 15 h and 1050 °C after 15 h, the IN718 alloy exhibited a mass gain of 4.41 mg/cm 2 and 10.84 mg/cm 2 , respectively, while the TiNbTaVW RHEA exhibited a mass loss of − 23.58 mg/cm 2 and − 45.92 mg/cm 2 , respectively, indicating that the IN718 alloy exhibited the best oxidation resistance. Thermal and growth stresses contributed to the pores, voids, cracks, and oxide layer spallation observed in the TiNbTaVW RHEA.

Synthesis and corrosion behavior of Mo15Nb20Ta10Ti35V20 refractory high entropy alloy

Thermal stability and corrosion behavior of a novel Zr22.5Ti22.5Hf22.5Ni22.5Ta10 high-entropy amorphous alloy

Tribo-corrosion resistance of Ti-Nb-Cr-Mo-Al refractory high-entropy alloys in molten aluminum

Corrosion Behavior of Hf0.5Nb0.5Ta0.5Ti1.5Zr Refractory High-Entropy in Aqueous Chloride Solutions

Microstructure and Mechanical Properties of the Ductile Al–Ti–Mo–Nb–V Refractory High Entropy Alloys

Corrosion behavior of refractory TiNbZrMoV high-entropy alloy coating in static lead‐bismuth eutectic alloy: A novel design strategy of LBE corrosion-resistant coating?

Thermal and corrosion properties of V-Nb-Mo-Ta-W and V-Nb-Mo-Ta-W-Cr-B high entropy alloy coatings

Corrosion Resistant Body-Centered Cubic VNbTa Refractory Medium-Entropy Alloy

Electrochemical corrosion and high temperature hot corrosion behavior of NbTaTiV and CrNbTaTiV high entropy alloy

Microstructure and wear behavior of a refractory high entropy alloy

Corrosion and passive behaviors of the Co-Cr-Fe-Ni-Nb eutectic high-entropy alloys in different electrolyte solutions

Microstructure, hardness, oxidation, and corrosion behavior of TiNbTaVW refractory high entropy alloy in 3.5 wt% NaCl and 1 M H 2 SO 4

Phase equilibria, microstructure, and high temperature oxidation resistance of novel refractory high-entropy alloys

Structures and Corrosion Properties of the AlCrFeNiMo0.5Tix High Entropy Alloys

Microstructure, Mechanical Properties, and Corrosion Behavior of MoNbFeCrV, MoNbFeCrTi, and MoNbFeVTi High-Entropy Alloys

Microstructure and Composition Evolution of a Fused Slurry Silicide Coating on MoNbTaTiW Refractory High-Entropy Alloy in High-Temperature Oxidation Environment

Mechanical properties and oxidation behavior of NbMoTaW x refractory high entropy alloys

The oxidation-resistance mechanism of WTaNbTiAl refractory high entropy alloy

Effect of Al content on the microstructure, properties, and oxidation behaviors at 900 °C of (MoNbCoCrAlxSi0.2)70Ti30 refractory high-entropy alloys coatings fabricated by electron beam cladding

Oxidation behavior of Ti-Nb-Mo-Al-Six refractory high entropy alloy at 1000°C

Microstructure, mechanical properties and lead-bismuth eutectic corrosion behavior of FeCrAlTiNb high-entropy alloy coatings