Abstract:An experimental study has been made of the effects of frictional heating on the deformation of solids rubbing at very high speeds and at reasonably heavy loads. A new method for measuring the friction under these conditions is described. A steel ball, rapidly spinning round its vertical axis, is allowed to fall a short distance and to bounce off an inclined flat solid surface. The friction of steel on various solids in a vacuum of ca . 10 -4 mm Hg, at sliding speeds up to 700 m/s, is determined from the measured direction of the ball’s horizontal velocity after the impact. In addition, separate piezo-electric measurements are made of the load and the friction force. Again the coefficient of friction is found to decrease with increasing sliding speed. The general behaviour is similar to that observed at light loads but there are important differences. With heavy loads the deformation of the solids appears to be primarily plastic. Within a very short time after being brought into contact with a fast-moving surface, solids with a sufficiently low melting point melt on a large scale so that a continuous film of molten material is developed over the area of contact. The resistance to motion is determined primarily by this liquid film so that it may now increase as the speed rises. The heating due to the shearing of this film causes the solid to melt away rapidly, and as a result the wear rate of such solids usually becomes great at high sliding speeds. Certain polymers, however, exhibit a greater wear resistance than metals and other solids which possess a low viscosity in the molten state. Calculations indicate that in these polymers, owing to their high viscosity, the temperature of the sheared film may be considerably higher than the melting temperature. As a consequence, a larger proportion of the heat developed by the shearing may be absorbed in the already molten material, and less heat will be available for further melting. Gas liberated by thermal decomposition may also reduce the friction and wear.

Thermal deformation in frictionally heated contact

Heat Analysis of Sliding Abrasive Particle Micro Contact Process by Finite Element Method

Temperature Rise in Frictional Sliding Contact of Elastic–Plastic Solids with Fractal Surface

Temperature Rise in Sliding Solids: Influence of Contact Pressure and Temperature on Thermal Conduction

Effect of thermo-elastic deformation on lubricated point contacts

Experimental and Finite Element Analysis of Frictional Heat Distribution during Sliding Friction

Friction and Temperature Behavior of Lubricated Thermoplastic Polymer Contacts

Fundamental wear mechanism of metals

Deformation, heating and melting of solids in high-speed friction

Influence of Groove Surface Texture on Temperature Rise under Dry Sliding Friction

The roles of adhesion, internal heat generation and elevated temperatures in normally loaded, sliding rough surfaces

Friction Reduction Due to Heating in the Sliding Contact of Smart Coating: Modeling of Mutual Effect

Thermomechanical modeling and transient analysis of sliding contacts between an elastic–plastic asperity and a rigid isothermal flat

Aging of the frictional properties induced by temperature variations

Thermal–Mechanical Coupling Analysis of Wheel–Rail Sliding Friction under Two-Point Contact Conditions

Static and sliding contact of rough surfaces: effect of asperity-scale properties and long-range elastic interactions

Elastic shakedown analysis of two-dimensional thermo-elastic rolling/sliding contact for a functionally graded coating/substrate structure with arbitrarily varying thermo-elastic properties

Joint finite size influence and frictional influence on the contact behavior of thermoelectric strip

Wear and Contact Temperature Evolution in Pin-on-Disc Tribotesting of Low-Metallic Friction Material Sliding Against Pearlitic Cast Iron

Modeling of Flash Temperature for Elastic Sliding Contact of Single Micro-Asperity Pair

"THERMOELASTIC DISPLACEMENT AND TEMPERATURE RISE IN A HALF-SPACE DUE TO A STEADY-STATE HEAT FLUX "