Abstract:Conformal cooling channels (CCCs) are widely employed in the plastic injection molding (IM) due to uniform cooling in the cooling stage. IM is a process that molten materials are pushed into the mold cavity. The cooling stage is an important part in the IM process since it takes most of the cycle time. According to practice experience, it is very difficult to improve the cycle time and quality of injection molded part simultaneously in the conventional straight drilled cooling system. Thus, improving warpage and cooling time simultaneously of the injection molded parts is a critical item in the IM. In this study, an effective method for reducing both warpage and cooling time of the wax patterns was proposed by changing the coolant temperature difference between the core and cavity inserts. It was found that both core insert with series connection CCCs and cavity insert with parallel connection CCCs is a good combination in the IM mold. The cooling efficiency of the core insert is increased from 42 to 54%, while the coolant temperature difference between the core and cavity inserts is 2 °C. The average deformation of the injection molded parts can be improved by 75.2%. The cooling time of the injection molded parts can be further reduced by 6%. The cooling time of the injection molded parts can be saved by about 30%, and the average deformation of the injection molded parts can be improved by about 60% compared with IM mold embedded with conventional cooling channel. The mechanism to minimize the amount of warpage of injection molded parts using coolant temperature difference between the core and cavity inserts is presented. Finally, the proposed method is also verified by practical implementation and comparison with experimental data. The experimental results found that the improvement rate of the average deformation of the molded parts is up to 74.5% and the cooling time of the molded parts can be reduced by approximately 15.7%. The variances compared with the simulation results are approximately 0.7% and 9.7%, respectively.

Injection molding for hollow products with a varying cross-sectional contour by using ice core technology

A Water-Soluble Core for Manufacturing Hollow Injection-Molded Products

Effect on Residual Wall Thickness of Parts with Floating Core Injection of Water-Assisted Injection Molding

Simulation and Experimental Analysis on Non-circular Cross-section Parts Residual Wall Thickness of Water-assisted Injection Molding

Rapid Development of an Injection Mold with High Cooling Performance Using Molding Simulation and Rapid Tooling Technology

Research on the Application of Injection Molding Simulation Technology in Mold Design

A simple method of improving warpage and cooling time of injection molded parts simultaneously

Study on Computer Simulation of Co-injection Molding

Visual Computer-based Simulation of Sandwich Injection Molding Process:Influence of Shape of Rectangle Goods and Injection Gate Location on Breakthrough Phenomenon of Core Melt

Experimental and numerical investigations on formation mechanisms of hollow structures in overflow water‐assisted injection‐molded parts of short‐glass‐fiber‐reinforced polypropylene

Improving Cooling Performance of Injection Molding Tool with Conformal Cooling Channel by Adding Hybrid Fillers

Design of Cooling System for Narrow Area of Automotive Injection Mold Based on Computer Technology

Cooling efficiency enhancement using a rapid tool with a surface-cooled waterfall cooling channel

Design of Injection Mould for Bowl

Improving the Quality and Productivity of Molded Parts with a New Design of Conformal Cooling Channels for the Injection Molding Process

Optimization Design of Injection Mold Conformal Cooling Channel for Improving Cooling Rate

Characterizations of polymer injection molding tools with conformal cooling channels fabricated by direct and indirect rapid tooling technologies

Adaptive Conformal Cooling of Injection Molds Using Additively Manufactured TPMS Structures

Design of Conformal Porous Structures for the Cooling System of an Injection Mold Fabricated by Additive Manufacturing Process

Effects of cooling channel layout on the cooling performance of rapid injection mold