Abstract:Applying parameter mapping theory, this paper establishes a new three dimension lattice-spring model with rotational degree of freedom (3D-LSMR). This 3D-LSMR contains nearest neighbor, next nearest neighbor and third nearest neighbor which highly increases the accuracy of system. Compared with the general lattice spring model, 3D-LSMR adds the rotational and tangential degrees of freedom, whose spring parameters are obtained by finite element parameter mapping. The traditional lattice spring model only considers the normal interaction between two points (the Poisson's ratio is fixed), which limits the application of the lattice spring model in a wider range of materials. Some scholars proposed to add shear spring into the traditional model to solve the problem of fixed Poisson's ratio, but the rotation invariance could not be maintained. The main reason is that the shear spring can't distinguish the difference of tangential velocity (or displacement) between the two particles due to the common rotation or shear. Therefore, the rotation of the whole rigid body may cause incorrect generation of additional strain energy inside the shear spring. 3D-LSMR model is able to maintain rotation invariance and reproduces different Poisson's ratios because of the spring parameters with rotational degrees of freedom and the rotation effect of lattice points. In this paper, the finite element stiffness matrix with rotational freedom is derived by using 3D-LSMR as the basic mechanical model, and the parameter mapping theory of spring stiffness coefficient is introduced. By means of numerical simulation, the large deflection of slender cantilever beam, elastic symmetrical collision and the simulation of dynamic fracture for concrete Lspecimen are checked and calculated respectively, and then the correctness of the model is verified. (C) 2020 Elsevier Ltd. All rights reserved.

Optimization of a lattice spring model with elastoplastic conducting springs: A case study

Topological properties of elastoplastic lattice spring models that determine terminal distributions of plastic deformations

Sweeping process approach to stress analysis in elastoplastic Lattice Springs Models with applications to Hyperuniform Network Materials

Design and Mechanical Experiment of Functionally-Graded Lattice Structure with Multiple Loading Conditions

Optimized Structural Designs for Stretchable Silicon Integrated Circuits

Lattice spring model with angle spring and its application in fracture simulation of elastic brittle materials

Mechanics of Noncoplanar Mesh Design for Stretchable Electronic Circuits

Enhanced Multi-Springs Model for Estimating Suction Caisson Responses under Cyclic Lateral Loading

Predicting the mechanical properties of spring networks

Topology optimization of gradient lattice structure under harmonic load based on multiscale finite element method

Structural optimization of ultra-thin leaf spring for weakening elastic hysteresis effect and enhancing fatigue life

Stress-constrained continuum topology optimization: a new approach based on elasto-plasticity

Lattice structure design optimization under localized linear buckling constraints

Surface Effects On The Elasticity Of Nanosprings

A three dimension lattice-spring model with rotational degree of freedom and its application in fracture simulation of elastic brittle materials

Topology Optimization of Hyperelastic Structures Using a Level Set Method

Optimal Design of Helical Springs of Power Law Materials

An Equivalent Axisymmetric Modeling Approach for Circumferential Springs under Large Deformation Based on Mechanical Anisotropy

A Full Range Experimental Study of Amplitude- and Frequency-Dependent Characteristics of Rubber Springs

Three-dimensional elastic–plastic lattice-spring model based on sapphire crystal structure and its application to impact characterisation studies

Transition boundaries and stiffness optimal design for multi-TPMS lattices