Abstract:Wireless Power Transfer (WPT) and wireless data communication are both important problems of research with various applications, especially in medicine. However, these two problems are usually studied separately. In this work, we present a joint study of both problems. Most medical electronic devices, such as smart implants, must have both a power supply to allow continuous operation and a communication link to pass information. Traditionally, separate wireless channels for power transfer and communication are utilized, which complicate the system structure, increase power consumption and make device miniaturization difficult. A more effective approach is to use a single wireless link with both functions of delivering power and passing information. We present a design of such a wireless link in which power and data travel in opposite directions. In order to aggressively miniaturize the implant and reduce power consumption, we eliminate the traditional multi-bit Analog-to-Digital Converter (ADC), digital memory and data transmission circuits all together. Instead, we use a pulse stream, which is obtained from the original biological signal, by a sigma-delta converter and an edge detector, to alter the load properties of the WPT channel. The resulting WPT signal is synchronized with the load changes therefore requiring no memory elements to record inter-pulse intervals. We take advantage of the high sensitivity of the resonant WPT to the load change, and the system dynamic response is used to transfer each pulse. The transient time of the WPT system is analyzed using the coupling mode theory (CMT). Our experimental results show that the memoryless approach works well for both power delivery and data transmission, providing a new wireless platform for the design of future miniaturized medical implants.

Enabling Wireless Communications, Energy Harvesting, and Energy Saving by Using a Multimode Smart Nonlinear Circuit (MSNC)

Enabling Wireless Communications, Energy Harvesting, and Energy Saving by Using a Multimode Smart Nonlinear Circuit (MSNC)

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

Performance Analysis and Experimental Verification of Mid-Range Wireless Energy Transfer Through Non-Resonant Magnetic Coupling

Circuit-Level Modeling and Simulation of Wireless Sensing and Energy Harvesting With Hybrid Magnetoelectric Antennas for Implantable Neural Devices

High-Performance Wireless Power and Data Transmission System for Medical Implant Devices Using ASK Modulation

On the performance of wireless powered communication with non-linear energy harvesting

Power Management System for Online Low Power RF Energy Harvesting Optimization

Performance Analysis And Optimisation Of Wireless Powered Decode-And-Forward Considering Circuit Power Consumption

Energy-Efficient Low-Power Circuit Techniques for Wireless Energy and Data Transfer in IoT Sensor Nodes

A Compact RF Energy Harvesting Wireless Sensor Node with an Energy Intensity Adaptive Management Algorithm

Integrated SWIPT Receiver with Memory Effects: Circuit Analysis and Information Detection

Network Topology Modulation for Energy and Data Transmission in Internet of Magneto-Inductive Things

Wireless Powered Communication Networks with Non-Ideal Circuit Power Consumption

Nonlinear MIMO Transceivers Improve Wireless-Powered and Self-Interference-Aided Relaying.

Dual-Band, Wide-Angle, and High-Capture Efficiency Metasurface for Electromagnetic Energy Harvesting

RF Energy Harvesting with Wide Input Power Range

An ultra‐low‐power CWM/SCM demodulator for inductive‐powered IMDs with the DRCF ratio of 50% and the powering index of 75%

Ultra low-power transceiver with novel FSK modulation technique and efficient FSK-to-ASK demodulation

Simultaneous Wireless Power Transfer and Data Communication Using Synchronous Pulse-Controlled Load Modulation

A 1/2/4mhz Multi-Mode Reconfigurable Lowpass/complex Bandpass CT ΣΔ Modulator for Short Range Wireless Receiver