Improved interfacial resistance and crystal-structure stability in a low-cobalt P2-type sodium-ion battery cathode material

William Rexhausen,Christian Parsons,Uma Garg,Deyang Qu,Prasenjit Guptasarma

2024-08-03

Abstract:We describe Na0.67Mn0.625Fe0.25Co0.125O2 (NMFCO), a P2-type sodium-ion battery cathode. Our composition, with significantly less Co than in an earlier study, shows discharge capacity close to 190 mAhg-1 and specific energy density exceeding 500 mWhg-1 in the 1.5 to 4.3 V range. The material also shows an improved structural stability over similar materials. Such changes, between the pristine phase (P63/mmc, P63 (OP4), or orthorhombic Cmcm) and the so-called Z phase, are endemic to other P2-type cathodes such as Na0.67Mn0.65Fe0.35O2 (NMFO). We propose two equivalent circuit models of impedance spectroscopy to understand electrochemical processes in our cells with a sodium metal anode. Our equivalent circuit modeling, combined with an analysis of the initial galvanostatic slope, reveals a significant reduction in the polarization and interfacial charge-transfer resistance at the solid electrolyte interface. We reveal that the combined effects of crystal structure stability, lower internal resistance, relatively high specific energy density, and improved battery health make this low-cobalt P2-type cathode composition a very promising candidate for new sodium-ion batteries.

Materials Science

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to improve the interfacial resistance and crystal structure stability of cathode materials for sodium - ion batteries under the condition of low cobalt content. Specifically, the researchers have developed a new P2 - type sodium - ion battery cathode material Na0.67Mn0.625Fe0.25Co0.125O2 (NMFCO), whose cobalt content is significantly lower than that in previous studies. Through this material, they aim to achieve the following goals:

1. **Improve the discharge capacity and energy density**: Research shows that within the voltage range of 1.5 to 4.3 V, the discharge capacity of NMFCO is close to 190 mAhg\(^{-1}\), and the specific energy density exceeds 500 mWhg\(^{-1}\).

2. **Improve the structural stability**: Compared with similar P2 - type cathode materials, NMFCO exhibits better structural stability, especially with less change when transforming from the original phase (P63/mmc, P63 (OP4), or orthorhombic Cmcm) to the so - called "Z" phase. This "Z" - phase change is common in other P2 - type cathode materials, such as Na0.67Mn0.65Fe0.35O2 (NMFO).

3. **Reduce the interfacial resistance**: Through the equivalent circuit modeling of electrochemical impedance spectroscopy (EIS), the researchers have revealed that the polarization and interfacial charge - transfer resistance of NMFCO at the solid - state electrolyte interface are significantly reduced.

4. **Improve the state of health of the battery**: It has been found that during the cycling process of NMFCO, the state of health (SoH) of the battery and the internal resistance do not decrease significantly, indicating that this material has good cycling stability and a long service life.

In conclusion, this paper explores new cathode materials for sodium - ion batteries by reducing the cobalt content, aiming to balance high energy density and cycling stability while reducing costs and environmental impacts. These improvements make NMFCO a promising candidate material for the new generation of sodium - ion batteries.