Abstract:Chirped pulse amplification (CPA) has been a commonly used methodology to obtain powerful ultrashort laser pulses ever since its first demonstration. However, wavelength-tunable CPA systems are much less common. Wavelength-tunable ultrashort and intense laser pulses are desirable in various fields such as nonlinear spectroscopy and optical parametric amplification. In this work, we report a 1720 nm–1800 nm tunable CPA system based on Tm-doped fiber. The tunable CPA system contains a seed laser, a pulse stretcher, two cascaded amplifiers and a pulse compressor. The dispersion-managed seed laser cavity emits wavelength-tunable laser pulses with pulse durations of several ps and spectral widths from 25 nm to 34 nm. After being stretched temporally to tens of ps, the laser pulses are then amplified in two-stage amplifiers and compressed in a Treacy-type compressor. At 1720 nm, the maximum average power of 126 mW is obtained with a pulse duration of 507 fs; at 1800 nm, the maximum average power of 264 mW is obtained with a pulse duration of 294 fs. The pulse repetition rates are around 22.7 MHz. We perform an analysis of the system design based on numerical simulations and go on to suggest further steps for improvement. To the best of our knowledge, this is the first demonstration of a tunable CPA system beyond 1.1 μm. Considering the specific wavelength range, this wavelength-tunable CPA system is highly desirable for biomedical imaging, sensing, and parametric amplifiers.

Suppression of Kerr-Induced Satellites in Multi-Pulse CPA

Suppression of Kerr-induced satellites in multi-pulse CPA

Spectral Peak Recovery in Parametrically Amplified THz-Repetition-Rate Bursts

Direct Frequency-Mode-Stable Laser Amplification at Terahertz Burst Rates

Phase of Kerr-based few-cycle parametric amplification

Numerical Model of Chirped Pulse Amplification in Pulsed Synchronously Pumped Low-Repetition-Rate Fiber Amplifiers

Spatiotemporal dispersion compensation for a 200-THz noncollinear optical parametric amplifier

Wavelength-Tunable Chirped Pulse Amplification System (1720 nm–1800 nm) Based on Thulium-Doped Fiber

On the Undesired Frequency Chirping in Photonic Time-Stretch Systems

Numerical Study of Spatial Chirp Distortion in Quasi-Parametric Chirped-Pulse Amplification

High-Contrast Chirped-Pulse Amplification Enabled by In-Band Noise Filtering

A route to high peak power and energy scaling in the mid-IR chirped-pulse oscillator-amplifier laser systems

A Pulse Compressor for A Chirped-Pulse Amplification System Based on A Frequency-Doubling Crystal and Grating

10-µJ-level femtosecond pulse generation in the erbium CPA fiber source with microstructured hollow-core fiber assisted delivery and nonlinear frequency conversion

Separation and amplification of Kelly sidebands and main soliton pulse in a 2-μm ultrafast fiber chirped pulse amplifier

1720nm-1800nm tunable chirped pulse amplification based on thulium-doped fiber

Single-stage few-cycle pulse amplification

Efficient Noncollinear Optical Parametric Chirped-Pulse Amplification in Oversaturation Region

Spatiotemporal Couplings Through a Nonlinear Phase in Broadband Optical Parametric Amplification

CEP-Stable, Few-Cycle, kHz OPCPAs for Attosecond Science: Energy Scaling and Coherent Sub-Cycle Pulse Synthesis

Numerical studies of optical parametric chirped pulse amplification