Abstract:We present results from the characterization and optimization of Skipper charge-coupled devices (CCDs) for use in a focal plane prototype for the Southern Astrophysical Research Integral Field Spectrograph (SIFS). We tested eight Skipper CCDs and selected six for SIFS based on performance results. The Skipper CCDs are 6k × 1k, 15 μm pixels, thick, fully depleted, p-channel devices that have been thinned to ∼250 μm, backside processed, and treated with an anti-reflective coating. We demonstrate a single-sample readout noise of <4.3 e − rms pixel −1 in all amplifiers. We optimize the readout sequence timing to achieve a readout noise of 0.5 e − rms pixel −1 after 74 non-destructive measurements, which can be accomplished in a region covering 5% of the detector area in a readout time of <4 minutes. We demonstrate single-photon-counting in all 24 amplifiers (four amplifiers per detector) with a readnoise of σ N ∼ 0.18 e − rms pixel −1 after N samp = 400 samples, and we constrain the degree of nonlinearity to be ≲1% at low signal levels (0 e − to 50 e − ). Clock-induced charge (CIC) remains an important issue when the Skipper CCD is configured to provide a large full-well capacity. We achieve a CIC rate of <1.45 × 10 −3 e − pixel −1 frame −1 for a full-well capacity of ∼900 e − , which increases to a CIC rate of ∼3 e − pixel −1 frame −1 for full-well capacities ∼40,000–65,000 e − . We also perform conventional CCD characterization measurements such as charge transfer inefficiency (3.44 × 10 −7 on average), dark current (∼2 × 10 −4 e − pixel −1 s −1 ), photon transfer curves, cosmetic defects (<0.45% "bad" pixels), and charge diffusion (point-spread function < 7.5 μm) to verify that these properties are consistent with expectations from conventional p-channel CCDs used for astronomy. Furthermore, we provide the first measurements of the brighter-fatter effect and absolute quantum efficiency (≳80% between 450 and 980 nm; ≳90% between 600 and 900 nm) using Skipper CCDs.

A Cryogenic readout integrated circuit with analog pile-up and in-Pixel ADC for high frame rate Skipper CCD-in-CMOS Sensors

A Cryogenic Readout IC with 100 KSPS in-Pixel ADC for Skipper CCD-in-CMOS Sensors

14-Bit Column Readout Circuits with Single-to-differential PGA Using Intentional Offset and Two-Step Scaled-Reference SAR ADC for CMOS Image Sensors

Skipper-in-CMOS: Non-Destructive Readout with Sub-Electron Noise Performance for Pixel Detectors

A 14-bit 150KS/s SAR ADC with PGA for CMOS Image Sensor

A 14-Bit 500-Ms/s Pipelined-SAR ADC in 28-Nm CMOS with Foreground and Background Calibration

A 14-bit 500MS/s and 1GS/s Configurable Pipelined ADC with Background Calibration

A Sub-Electron-Noise Multi-Channel Cryogenic Skipper-CCD Readout ASIC

An Indirect Time-of-Flight SPAD Pixel With Dynamic Comparator Reuse for a Single-Slope ADC

Characterization and Optimization of Skipper CCDs for the SOAR Integral Field Spectrograph

A CMOS SPAD Sensor With a Multi-Event Folded Flash Time-to-Digital Converter for Ultra-Fast Optical Transient Capture

Time-gated SPAD camera with reconfigurable macropixels for LIDAR applications

A 12-bit compact column-parallel SAR ADC with dynamic power control technique for high-speed CMOS image sensors

Design and Evaluation of EMPIX2, a 100 Kfps, High Dynamic Range Pixel Detector Readout ASIC for Electron Microscopy

A Pixel Readout Circuit for Hybrid SDD and CMOS Technology

The SparkPix-S ASIC for the sparsified readout of 1 MHz frame-rate X-ray cameras at LCLS-II: pixel design and simulation results

An area‐effective and low‐power single‐slope ADC for DCG imaging CMOS image sensor

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

High-Precision GRO-Based ROIC Adopting Sliding Scale Average Method for SPAD Array

Smart Pixels: In-pixel AI for on-sensor data filtering

A multi-channel silicon package for large-scale skipper-CCD experiments