Abstract:Dose evaluation and direct measurements are fundamental for radiation protection in non-conventional accelerator facilities, both before and after the primary and secondary shielding. In this paper, we will report about the experimental setup, data acquisition and analysis, together with FLUKA modeling, of the dose measurements test carried out in the Beam Test Facility (BTF) of the INFN - Frascati's National Laboratories (LNF), where an intense mixed field is produced and measured with thermoluminescent dosimeters. BTF is an extraction and transport line of DA Φ NE LINAC (Buonomo et al. 2021; Mazzitelli et al. 2003) . It is optimized for electrons and positrons production in a wide range of intensity, energy (30 MeV – 800 MeV), beam spot dimensions and divergence, using both primary and secondary beam of the DA Φ NE LINAC. Through the years, the BTF has gained an important role in particle detectors test and development with electron/positron beam. A small fraction of the BTF's shifts have been dedicated to radiation damage test using LINAC electron primary beam up to 5 x 1010 e-/s. As radiation protection group of the LNF, we evaluated the dose when electrons impinging on a Pb target from: i) photon Bremsstrahlung production; ii) photoneutron production. Three dedicated tests with 503 MeV electrons impinging on a ∼ 16 cm thick Pb target have been carried out in February, June 2022 and in January 2023, using TLD700 and TLD600, measuring doses at several charge intervals. The aim of this study focuses on evaluating dosimetric quantities produced by the mixed field, air kerma for the photon component, and ambient dose equivalent for the neutron one, using thermoluminescence dosimeters calibrated with low-energy standards: Cs-137 and Am-Be. The approach adopted involves the use of Monte Carlo simulations of the experiment, both to benchmark against experimental measurements and to validate the results obtained for energies higher than those of calibration. The results of this comparison show excellent agreement between measured and simulated quantities in the forward direction, allowing us to conclude and confirm the validity of the calibrations themselves.

Characterization of the PADME positron beam for the X17 measurement

Characterization of the PADME positron beam for the X17 measurement

Beam diagnostics with silicon pixel detector array at PADME experiment

Status and Prospects of PADME

Design and performance of the front-end electronics of the charged particle detectors of PADME experiment

Characterization and Performance of PADME's Cherenkov-Based Small-Angle Calorimeter

Resonant search for the X17 boson at PADME

First results on the performance of the PADME electromagnetic calorimeter

Photon and neutron dose evaluation at the beam test facility of the INFN - National laboratory of Frascati

Measurement of the absolute efficiency of the X-ARAPUCA photon detector for the DUNE Far Detector 1

A measurement of proton-carbon forward scattering in a proof-of-principle test of the EMPHATIC spectrometer

Performance assessment of the HERD calorimeter with a photo-diode read-out system for high-energy electron beams

Charged particle's flux measurement from PMMA irradiated by 80 MeV/u carbon ion beam

Measurement of the response function of the PIENU calorimeter

The Frascati Beam Test Facility

Measurement of Compton Scattering at MAMI for the Extraction of the Electric and Magnetic Polarizabilities of the Proton

The ENUBET positron tagger prototype: construction and testbeam performance

First Measurement of the Total Inelastic Cross-Section of Positively-Charged Kaons on Argon at Energies Between 5.0 and 7.5 GeV

Characterization of LAPPD timing at CERN PS testbeam

PARSIFAL: a toolkit for triple-GEM parametrized simulation