On-ground calibration of the X-ray, gamma-ray, and relativistic electron detector onboard TARANIS

Yuuki Wada,Philippe Laurent,Damien Pailot,Ion Cojocari,Eric Bréelle,Stéphane Colonges,Jean-Pierre Baronick,François Lebrun,Pierre-Louis Blelly,David Sarria,Kazuhiro Nakazawa,Miles Lindsey Clark

DOI: https://doi.org/10.1117/1.JATIS.10.2.026005

2024-05-08

Abstract:We developed the X-ray, Gamma-ray and Relativistic Electron detector (XGRE) onboard the TARANIS satellite, to investigate high-energy phenomena associated with lightning discharges such as terrestrial gamma-ray flashes and terrestrial electron beams. XGRE consisted of three sensors. Each sensor has one layer of LaBr$_{3}$ crystals for X-ray/gamma-ray detections, and two layers of plastic scintillators for electron and charged-particle discrimination. Since 2018, the flight model of XGRE was developed, and validation and calibration tests, such as a thermal cycle test and a calibration test with the sensors onboard the satellite were performed before the launch of TARANIS on 17 November 2020. The energy range of the LaBr$_{3}$ crystals sensitive to X-rays and gamma rays was determined to be 0.04-11.6 MeV, 0.08-11.0 MeV, and 0.08-11.3 MeV for XGRE1, 2, and 3, respectively. The energy resolution at 0.662 MeV (full width at half maximum) was to be 20.5%, 25.9%, and 28.6%, respectively. Results from the calibration test were then used to validate a simulation model of XGRE and TARANIS. By performing Monte Carlo simulations with the verified model, we calculated effective areas of XGRE to X-rays, gamma rays, electrons, and detector responses to incident photons and electrons coming from various elevation and azimuth angles.

Instrumentation and Methods for Astrophysics,Atmospheric and Oceanic Physics

What problem does this paper attempt to address?

This paper mainly describes the ground verification and calibration process of the X-ray, gamma-ray, and relativistic electron detector (XGRE) carried by the TARANIS satellite. The detector is designed to study high-energy phenomena related to lightning discharges, such as Terrestrial Gamma-ray Flashes (TGFs) and Terrestrial Electron Beams (TEBs). The paper provides a detailed introduction to the sensor structure of XGRE, including three layers of LaBr3 crystals for detecting X-rays and gamma-rays, and two layers of plastic scintillators for distinguishing electrons and charged particles. Before launch, the detector undergoes thermal cycling testing and calibration testing on the satellite.

The paper points out that TGFs are bremsstrahlung photons produced by relativistic electrons accelerated by strong electric fields in lightning, but the mechanisms of electron acceleration and multiplication are still uncertain. XGRE consists of three sensors, each installed at a different angle to adapt to radiation from different directions. Through Monte Carlo simulations, researchers have calculated the effective area of XGRE for X-rays, gamma-rays, electrons, and incoming photons and electrons from different azimuth angles.

During the ground verification and calibration phase, the components of the detector undergo a series of tests, including performance verification of the detection unit, thermal cycling testing of the sensors, and calibration testing on the entire satellite system. These tests ensure the sensitivity of XGRE to high-energy radiation in the space environment and quantify its response.

However, due to a launch failure, the TARANIS satellite failed to reach its intended orbit. Nevertheless, the development process of the satellite still has important reference value for future space missions. The paper also provides detailed descriptions of the verification of response time, the impact of temperature changes on gain, and the influence of gamma-ray sources at different locations on the detector.