Abstract:Solar thermal power generation is one of the effective ways to utilize solar energy. It plays an important role in alleviating energy crisis and environmental pollution and has far-reaching social significance. The selective absorption coating is an important part of solar collecting tube, and the key factor to determine the conversion efficiency of solar energy and heat energy. In order to characterize the optical properties of solar selective absorption coatings under high temperature conditions, a new method for measuring the spectral absorptivity of high temperature metal-ceramic selective absorption coatings was proposed. Based on Fourier spectrometer with double detector and integrating sphere with heating function, a high-vacuum measurement device was developed, which has the function of high temperature oxidation resistance and working temperature simulation. The Mo-SiO2 selective absorption coating with the typical double absorption layer, prepared by magnetron sputtering, was used as the sample for measurement. In addition, the solar spectral absorptivity of sample at different temperature was measured in the spectral range of 0. 3 similar to 2. 5 m and temperature range from room temperature to 700 degrees C. Measurement values at the room temperature were compared to the values calculated from the effective medium theory and matrix formula, and results show a good consistency. Because the maximum deviation is only 2. 9%, the feasibility of measurement method is verified. The measurement of high temperature spectral absorptivity has important guiding significance and promoting function for optimization of design parameters and enhancement of absorption performance.

First spectral emissivity study of a solar selective coating in the 150 to 600 C temperature range

Measuring Method of the Spectral Absorptivity for Solar Selective Absorption Coatings at High Temperature

Importance of the spectral emissivity measurements at working temperature to determine the efficiency of a solar selective coating

Spectral reflectance data of a high temperature stable solar selective coating based on MoSi2 -Si3N4

A New Solar Spectral Selective Absorbing Coating of SS–(Fe3O4)/Mo/TiZrN/TiZrON/SiON for High Temperature Application

The Investigation of Thermal Stability of Al/NbMoN/NbMoON/SiO 2 Solar Selective Absorbing Coating

In situ high-temperature emissivity measurements of heat-treated, silicon coated stainless steel for solar thermal applications

Spectral Properties and Thermal Stability of Solar Selective Absorbing Alni-Al2o3 Cermet Coating

On the thermal stability and performance evaluation of Si doped transition metal nitride/oxide nanolayered multilayer-based spectrally selective absorber for high-temperature photothermal applications

Spectral Optimization of Solar Selective Absorbing Coating for Parabolic Trough Receiver

Angular Solar Absorptance and Thermal Stability of Mo–SiO2 Double Cermet Solar Selective Absorber Coating

Study of Selective Solar Absorption Cermet Coating (Invited)

COMPARISON OF THE NORMAL THERMAL EMITTANCE MEASUREMENT OF SOLAR SELECTIVE COATING AT THE MIDDLE TEMPERATURES

The Spectral Properties and Thermal Stability of Alcr-Alcron Solar Selective Absorber Coating

High-temperature Air-Stable Solar Absorbing Coatings Based on the Cermet of MoSi2 Embedded in SiO2

New experimental device for high-temperature normal spectral emissivity measurements of coatings

An Ultra-High Temperature Stable Solar Absorber Using the ZrC-Based Cermets

Cr-(CrN/TiAlN)m-AlSiN-AlSiO open-air stable solar selective coating for concentrated solar thermal power applications

THERMAL STABILITY OF Mo-SiO2 SOLAR SELECTIVE COATINGS AT HIGH TEMPERATURES IN AIR

Optical Design and Co-Sputtering Preparation of High Performance Mo–SiO2 Cermet Solar Selective Absorbing Coating

Spinel Cu-Mn-Cr Oxide Nanoparticle-Pigmented Solar Selective Coatings Maintaining >94% Efficiency at 750 degrees C