Abstract:In cryogenic and high vacuum systems, radiation mode of heat transfer is the primary source of energy interaction owing to the wide temperature differentials and very low temperatures and pressures. Measurement of radiative properties such as emissivity is crucial in the design of cryogenic systems. Emissivity measurement at cryogenic temperatures requires careful consideration of the sample preparation and measurement conditions to ensure accuracy and reliability. Most experimental techniques developed so far are complex in their design and equipment, and they work only on a single measuring method. To address these challenges, this research has proposed a simpler and hybrid experimental setup that could employ both calorimetric and heat flux methods to directly measure the total hemispherical emissivity in the range 90 K–180 K. Experiments were conducted with five types of materials (black paint, stainless steel, aluminum foil, aluminized mylar foil, and copper sheet) by using both methods, and the results were validated with the literature data. The data obtained by calorimetric and heat flux methods for each sample showed a high level of consistency with each other, with a variation of only ±1.5%. Moreover, the discrepancy between the measured and literature data was within the acceptable range of 0.3%–10%. The total hemispherical emissivity of mechanically treated copper was higher than that of chemically polished copper by 11%. This simplified setup has incorporated all possible means to minimize heat leakages into and from the cryostat while maintaining accuracy. The obtained data can be used to accurately estimate the radiation heat loads in cryopumps and other cryogenic systems that use similar components.

Experimental verification of the anomalous skin effect in copper using emissivity measurements

Optical properties of metals: Infrared emissivity in the anomalous skin effect spectral region

Emissivity measurements on noble metals: validation of a free-electron description including the anomalous skin effect

Spectral emissivity of copper and nickel in the mid-infrared range between 250 and 900 $^{\circ}$C

The anomalous skin effect and copper cavity operation at cryogenic conditions

Study of the anomalous skin effect of normal conducting film

Study of the skin effect in superconducting materials

Local Features of the Fermi Surface Curvature and the Anomalous Skin Effect in Metals

First Principle Measurements of Thermal Emittance for Copper and Magnesium

Evidence of vectorial photoelectric effect on Copper

IR radiometer sensitivity and accuracy improvement by eliminating spurious radiation for emissivity measurements on highly specular samples in the 2 to 25 μm spectral range

Novel approach to assess the emissivity of the human skin

Theoretical Calculation of Photoemission Yield Spectrum of Space Metal Materials

Ab initio calculations of the dynamical response of copper

Kinetic theory of the non-local electrodynamic response in anisotropic metals: skin effect in 2D systems

A hybrid experimental configuration for emissivity measurement at cryogenic temperatures

Nonreciprocal thermal radiation in ultrathin magnetized epsilon-near-zero semiconductors

Electronic Structure and X-Ray Absorption Near Edge Spectroscopy of Copper Oxides

Spectrally Sharp Near-Field Thermal Emission: Revealing Some Disagreements between a Casimir-Polder Sensor and Predictions from Far-Field Emittance

Consistency between reflection M-EELS and optical spectroscopy measurements of the long-wavelength density response of Bi$_2$Sr$_2$CaCu$_2$O$_{8+x}$

Experimental Research on Influence of Gas Adsorption on Secondary Electron Emission of Copper Surface