Abstract:2D and 3D numerical simulations with two-fluid approach were conducted to investigate the gas-liquid flow dynamic behaviour in a rectangle bubble column. In the simulations, k-ε and RNG k-ε turbulent models, which account for the influence of the bubbles on liquid phase turbulence, were employed to study the effect of such models on predication of the dynamic behaviour of the bubble plume. In addition, the influence of different interfacial force closures such as drag, lift and added mass forces were also assessed. The simulation results indicated that for the 2D cases, the use of k-ε model could merely yield a steady flow pattern with one big liquid circulation, while the use of RNG k-ε model could produce a steady flow pattern, characterised by the appearance of three large vortices. However, all the 3D simulations have captured the plume meandering behaviour. The results showed that the value of the turbulence eddy viscosity predicted with 3D simulation was one order smaller than that with 2D simulation. Particularly, the meandering period of the bubble plume predicted by RNG k-ε model, was obviously smaller than that predicted using k-ε model in 3D simulations. The former gave the average turbulence eddy viscosity to be almost one third of that predicted by the latter. The assessment of the use of different interfacial force closures and their combinations showed that the lift force has a pronounced effect on the result of bubbly flow behaviour besides the drag force. It was found that the predicted meandering period was much greater than the experimental observations without the inclusion of the lift force, while the predicted period was consistent with the experimental result when the lift force was considered. Our simulations also revealed that the inclusion of the added mass force could notably improve the prediction results.

Planar bubble plumes from an array of nozzles: Measurements and modelling

Planar bubble plumes from an array of nozzles: Measurements and modelling

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Numerical Modelling of Bubbling Flow Dynamic Behaviour in a Bubble Column

Active Acoustic Measurement of Sound Speed for Quantifying Underwater Gaseous Bubble Emissions

Bubble Statistics in Shallow Angle Plunging Liquid Jets

Experimental Investigation of the Behaviors of Highly Deformed Bubbles Produced by Coaxial Coalescence

Numerical Simulations of Bubble Formation and Acoustic Characteristics from a Submerged Orifice: the Effects of Nozzle Wall Configurations

Acoustic analysis on jet-bubble formation based on 3 D numerical simulations

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

Numerical Simulations and Experimental Validation on Passive Acoustic Emissions During Bubble Formation

Experimental Study on Asymmetric Bubbles Rising in Water: Morphology and Acoustic Signature

Study of an air bubble curtain along a wall in water and radiated noise mitigation

Bubble curtains for noise mitigation: one vs. two

Direct numerical simulation of deformable rising bubbles at low Reynolds numbers

A new approach of acoustic characteristics analysis in jet-bubble noise

Bubble curtain modelling: analytical prediction of piling noise mitigation

Theoretical analysis and experimental investigation of air-bubble-stream-induced water circulation

Experimental Study of Non-Uniform Bubbles in a Plume

Modelling and simulation of the dynamic flow behaviour in a bubble column

Modeling time-delayed acoustic interactions of cavitation bubbles and bubble clusters