Bubble curtains for noise mitigation: one vs. two

Simon Beelen,Marten Nijhof,Christ de Jong,Leen van Wijngaarden,Dominik Krug

2024-10-18

Abstract:Bubble curtains are widely used to protect marine life from exposure to noise during offshore construction. However, operating a bubble curtain is costly. Therefore optimizing the acoustic effect of the available air is important. An interesting approach is to split the airflow rate into two separate bubble curtains, rather than one single curtain. This concept is tested experimentally and numerically. The experiments and the model show an increase in performance of the compressed air when it is split between two manifolds. An increased insertion loss of up to 11dB is measured. This increase in performance is possibly due to the fact that the reflective properties of the bubble curtains are maintained when halving the airflow rate. In effect, by splitting the airflow a second acoustic barrier is added. Additionally, the variations in the bubble curtain performance between individual measurements are shown to be largely caused by temporal variations in the air distribution. The applicability of equivalent fluid models for bubble curtains is discussed, and it is shown that accounting for a gap in the bubble curtain, close to the manifold where the bubble curtain is not fully developed, results in better agreement between the modelled and the measured insertion loss.

Fluid Dynamics,Applied Physics

What problem does this paper attempt to address?

This paper attempts to address the issue of how to reduce noise impact on marine life during offshore construction by optimizing the bubble curtain. Specifically, the study explores whether dividing the same air flow into two separate bubble curtains, instead of using a single bubble curtain, can improve noise reduction effectiveness. Through experiments and numerical simulations, the study found that this method can significantly enhance the acoustic effect of compressed air, with a maximum insertion loss of up to 11 decibels. This indicates that by distributing the air flow into two bubble curtains, noise reduction performance can be improved without increasing the total air flow.