Abstract:Wind tunnel test and numerical simulation are two powerful methods to study air flows and pollutant dispersions around urban buildings environment. As commonly known, the development of a successful numerical model should be firstly validated by experimental results, usually by wind tunnel data [1,2], a numerical model is ultimately needed to simulate the air flows and pollutant dispersions in real street canyons [3]. It is obvious that wind tunnel models and real canyons are of different scales. The scaling effects for wind tunnel tests have already been investigated on some simple models, such as single building and normal street canyon with the aspect ratio near 1.0 (AR, denoted by building height, H, over road width, W) [4,5]. But the scaling effects on the flows around complex buildings or in real street canyons still need to be examined. In wind tunnel test, air is often used as the experimental fluid. The air velocities in the wind tunnels are several metres per second, rarely more than 20m s 1 [5,6], which are similar to the velocities in the real canyon environment. But wood blocks with height of several centimetres, subject to the experimental conditions, are adopted for the street canyon models, following that the dimensions of wood blocks are about two orders of magnitudes smaller than the real buildings. Thus, the wind tunnel experiments only satisfy the geometric similarity, but miss the Reynolds dynamic similarity in nature. On the other hand, the numerical simulations of turbulent flows with high Reynolds numbers often demand large computing resources, so that the downscaling model is always used to simulate the air flows and pollutant dispersions in urban street canyons. In such cases, building models are set in several centimetres and incoming wind velocities are given similar to the real background wind velocities; this treatment is the same as the wind tunnel test [7,8]. This means that the downscaling simulations would just satisfy the geometric similarity, but miss the Reynolds dynamic similarity. The downscaling modelling was based on the Townsend’s ‘‘Reynolds number similarity’’ hypothesis [9] and determined by the critical Reynolds numbers [1,10]. The Townsend’s hypothesis is that, in the absence of thermal and Coriolis effects and for a specified flow system whose boundary conditions are expressed non-dimensionally in terms of a characteristic length, L, and velocity, UR, the flow structure is similar with all sufficiently high Reynolds numbers. Based on the ‘‘Reynolds number similarity’’ hypothesis, the critical Reynolds numbers are only determined by the representation of minor changes in flow structures or wind profiles, in which actually the wind

The similitude of indoor airflow in natural ventilation for a reduced-scale model: Investigation of nonisothermal flow fields by RANS simulation

A Comprehensive High Reynolds Number Effects Simulation Method for Wind Pressures on Cooling Tower Models

Wind tunnel experiment of ventilation rate and airflow characteristics in natural ventilation induced by wind and buoyancy effects

Numerical studies on Re-independence and influence region definition for flow and dispersion within street-indoor scale model

Numerical studies on issues of Re-independence for indoor airflow and pollutant dispersion within an isolated building

A Discussion of Low Reynolds Number Flow for the Two-Dimensional Benchmark Test Case

Large-eddy simulations to define building-specific similarity relationships for natural ventilation flow rates

Validation of CFD Simulations for Natural Ventilation

Reduced-Scale Numerical Study on the Effects of Radiant Floor Heating Integrated with Natural Ventilation on Indoor Flow and Dispersion

Revisit of Wind Flows Between Wind Tunnels and Real Canyons – the Viewpoint of Reynolds Dynamic Similarity

Natural cross-ventilation in buildings: Building-scale experiments, numerical simulation and thermal comfort evaluation

A simple model to study the influence of fluctuating airflow on the effective air exchange rate when using natural ventilation

Natural ventilation of large air masses: experimental and numerical techniques review

A simplified system for indoor airflow simulation

Effects of Radiant Floor Heating Integrated with Natural Ventilation on Flow and Dispersion in a Newly Decorated Residence

Review of natural ventilation models

Wind-tunnel Measurements for Thermal Effects on the Air Flow and Pollutant Dispersion Through Different Scale Urban Areas

Natural ventilation in buildings: measurement in a wind tunnel and numerical simulation with large-eddy simulation

Experimental Investigation of Indoor Air Flows in a Model Room

Wind-induced ventilation rate of single-sided ventilation in a building with internal partition

Numerical simulation study on the effect of internal heat source on pumping ventilation