Abstract:A detailed study at the microscopic level of the transient behavior of boiling phenomena during quenching of an AISI 304 stainless steel, conical-end, cylindrical probe in flowing water at 60 °C was conducted using high-speed video recordings and cooling curve data acquisition. Two free-stream velocities (0.2 and 0.6 m/s) and two initial probe temperatures (850 and 950 °C) were investigated. It was complemented by video recordings at 60 fps to calculate the wetting front velocity. Surface heat flux histories at the thermocouple positions were estimated by solving the corresponding Inverse Heat Conduction Problem. As the water velocity increases the duration of the vapor film at each thermocouple position shortens and the difference among cooling curves at the thermocouple positions decreases. Increasing the initial temperature increases the duration of the vapor film stage. The wetting front velocity increased from 4 to 6 m/s. The time to reach the maximum surface heat flux at the position of the thermocouple closest to the probe tip ranged from 9.7 to 18 s. Undulations at the vapor-liquid interface that appear periodically and propagate in the direction of quenchant flow were observed early during the vapor film stage. Later, before the collapse of the vapor film, a kind of a shock wave was generated at the probe tip which modified the appearance of the film. Once the Leidenfrost temperature is reached, a wetting front (which consists of many small bubbles that coalesce rapidly in a very small area) is formed and travels in the direction of quenchant flow while fewer and larger bubbles nucleate and grow upstream. The nucleation, growth and detachment of the larger bubbles was studied; as the free-stream velocity decreases larger values of bubble maximum diameter and half-life time were observed, while the initial temperature has a marginal effect on these quantities.

A device to record ultra-rapid cooling profiles

Facilitating high pressure phase-transition research and kinetics studies at subzero temperatures using self-cooling laboratory units.

A Rapid-Quench Technique for Multi-Anvil High-Pressure-temperature Experiments.

Extending Cooling Rate Performance of Fast Scanning Chip Calorimetry by Liquid Droplet Cooling

Micron-Scale Apparatus for Measurements of Thermodiffusion in Liquids

Design and testing of low temperature part of an UHV SPM microscope

Compact Ultrahigh Vacuum Sample Exchange Device with Wide Temperature Range

Theoretical investigations of a novel microfluidic cooling/warming system for cell vitrification cryopreservation

Direct Measurement of the Critical Cooling Rate for the Vitrification of Water

Numerical Investigation Of A Novel Microfluidic System And Its Application In Achieving Ultra-Fast Cooling/Warming Rates For Cell Vitrification Cryopreservation

A Detailed Study of Boiling Phenomena in Forced Convective Quenching Experiments

Integrated cooling system for microfluidic PDMS devices used in biological microscopy studies

Experimental Demonstration of a 10 K Sorption Cryocooler Stage

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

Methods to stabilize aqueous supercooling identified by use of an isochoric nucleation detection (INDe) device

Combined Raman spectroscopy and electrical transport measurements in ultra-high vacuum down to 3.7 K

A precision cryostat design for manual and semi-automated cryo-plunge instruments

Non-linear physical aging of supercooled glycerol induced by large upward ideal temperature steps monitored through cooling experiments

Investigation on the Linear Cooling Method of Microfluidic Chip Based on Thermoelectric Cooler

Performance Comparison of Different Rapid Freeze–Quench Strategies for Electron Paramagnetic Resonance

In situ observation the interface undercooling of freezing colloidal suspensions with differential visualization method