Real-time experimental demonstrations of a photonic lantern wavefront sensor

Jonathan W. Lin,Michael P. Fitzgerald,Yinzi Xin,Yoo Jung Kim,Olivier Guyon,Barnaby Norris,Christopher Betters,Sergio Leon-Saval,Kyohoon Ahn,Vincent Deo,Julien Lozi,Sébastien Vievard,Daniel Levinstein,Steph Sallum,Nemanja Jovanovic

2023-12-21

Abstract:The direct imaging of an Earth-like exoplanet will require sub-nanometric wavefront control across large light-collecting apertures, to reject host starlight and detect the faint planetary signal. Current adaptive optics (AO) systems, which use wavefront sensors that reimage the telescope pupil, face two challenges that prevent this level of control: non-common-path aberrations (NCPAs), caused by differences between the sensing and science arms of the instrument; and petaling modes: discontinuous phase aberrations caused by pupil fragmentation, especially relevant for the upcoming 30-m class telescopes. Such aberrations drastically impact the capabilities of high-contrast instruments. To address these issues, we can add a second-stage wavefront sensor to the science focal plane. One promising architecture uses the photonic lantern (PL): a waveguide that efficiently couples aberrated light into single-mode fibers (SMFs). In turn, SMF-confined light can be stably injected into high-resolution spectrographs, enabling direct exoplanet characterization and precision radial velocity measurements; simultaneously, the PL can be used for focal-plane wavefront sensing. We present a real-time experimental demonstration of the PL wavefront sensor on the Subaru/SCExAO testbed. Our system is stable out to around ~400 nm of low-order Zernike wavefront error, and can correct petaling modes. When injecting ~30 nm RMS of low order time-varying error, we achieve ~10x rejection at 1 s timescales; further refinements to the control law and lantern fabrication process should make sub-nanometric wavefront control possible. In the future, novel sensors like the PLWFS may prove to be critical in resolving the wavefront control challenges posed by exoplanet direct imaging.

Instrumentation and Methods for Astrophysics

What problem does this paper attempt to address?

This paper attempts to solve the wave - front control problems faced when directly imaging Earth - like exoplanets. Specifically, in order to suppress the light of the host star and detect the faint planetary signal, sub - nanometer - level wave - front control needs to be achieved on large - aperture telescopes. Current adaptive optics (AO) systems cannot reach the required precision due to problems such as non - common - path aberrations (NCPAs) and petaling modes.

### Main problems
1. **Non - common - path aberrations (NCPAs)**: These are aberrations caused by the difference between the sensing path and the scientific observation path in the instrument.
2. **Petaling Modes**: These are caused by the discontinuous phase aberrations at the segment boundaries of the segmented primary mirror, especially challenging for future 30 - meter - class telescopes.

### Solutions
To solve these problems, the paper proposes a new wave - front sensor architecture - Photonic Lantern (PL), which can couple distorted light into single - mode fibers and is used for focal - plane wave - front sensing. In this way, PLWFS (Photonic Lantern Wave - front Sensor) can perform real - time monitoring and correction of low - order aberrations on the real scientific focal plane, thus avoiding the problems existing in traditional wave - front sensors.

### Experimental verification
The paper shows a real - time experimental demonstration of PLWFS on the Subaru/SCExAO test platform. The experimental results show that PLWFS can remain stable within a low - order Zernike wave - front error range of approximately ±400 nm and can effectively correct petaling modes. When injecting a low - order time - varying error of about 30 nm RMS, the system can achieve a suppression effect of about 10 times on a time scale of 1 second.

### Future prospects
Future work will further optimize the control algorithm and the manufacturing process of the photonic lantern to achieve sub - nanometer - level wave - front control. In addition, PLWFS is expected to become a key component of the next - generation high - contrast imaging instruments, facilitating the direct imaging and characterization of Earth - like exoplanets.

### Formula summary
The formulas involved in the paper are mainly used to describe the response characteristics of the wave - front sensor and the behavior of the control system. For example, the simulation of the dynamic wave - front error (WFE) uses the following autoregressive formula:

\[
z_{j}^{n + 1}=e^{-\frac{1}{t_{c}}} z_{j}^{n}+a_{j} \sqrt{1 - e^{-\frac{2}{t_{c}}}} m_{n}
\]

where:
- \(z_{j}^{n}\) is the amplitude of the \(j\) - th mode at the \(n\) - th time step.
- \(t_{c}\) is the decorrelation time (in units of frames).
- \(a_{j}\) is the desired average amplitude of mode \(j\) (in units of radians RMS).
- \(m_{n}\) is the \(n\) - th sample of a Gaussian - distributed random variable with a mean of 0 and a standard deviation of 1.

In addition, the complex - valued rejection transfer function of the classical adaptive optics loop is:

\[
h_{\text{rej}, j}(f)=\left[1 + g_{j} \operatorname{sinc}(T_{e} f) e^{-\pi i f\left(T_{e}+2\tau\right)}\right]^{-1}
\]

where:
- \(\operatorname{sinc}(x)=\frac{\sin(\pi x)}{\pi x}\)
- \(g_{j}\) is the gain of mode \(j\).
- \(l_{j}\) is the leakage term of mode \(j\).
- \(T_{e}\) is the detector integration time.
- \(\tau\) is the loop delay.

For static aberrations, the rejection function simplifies to:

\[
h_{\text{rej}, j}(f = 0)=\frac{1 - l_{j}}{1 - l_{j}+g_{j}}
\]

These formulas ensure the accurate modeling and control of wave - front errors.