Abstract:Complementary metal-oxide semiconductor (CMOS) sensors have been widely used as soft X-ray detectors in several fields owing to their recent developments and unique advantages. The parameters of CMOS detectors have been extensively studied and evaluated. However, the key parameter signal-to-noise ratio in certain fields has not been sufficiently studied. In this study, we analysed the charge distribution of the CMOS detector GSENSE2020BSI and proposed a two-dimensional segmentation method to discriminate signals according to the charge distribution. The effect of the two-dimensional segmentation method on the GSENSE2020BSI dectector was qualitatively evaluated. The optimal feature parameters used in the two-dimensional segmentation method was studied for G2020BSI. However, the two-dimensional segmentation method is insensitive to feature parameters.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is: how to improve the signal - to - noise ratio (SNR) of CMOS detectors in low - energy soft X - ray detection, especially for low - energy X - ray events such as the carbon Kα line (277 eV), while minimizing signal loss. Specifically, existing methods such as adjusting the threshold can remove noise, but have limited effects on multi - pixel events and it is difficult to effectively distinguish between signals and noise without sacrificing the number of signals. Therefore, the researchers proposed a new noise discrimination method based on charge distribution, hoping to significantly reduce the lower energy limit of low - energy X - ray events and improve the SNR without affecting the number of signals. ### Research Background Complementary metal - oxide - semiconductor (CMOS) sensors have been widely used in the field of soft X - ray detection due to their small pixel size, high quantum efficiency, low read - out noise, wide operating temperature range, high time resolution and low cost. However, one of the key parameters of CMOS detectors - the signal - to - noise ratio (SNR) - has not been fully studied. Especially in the field of astronomy, a higher SNR means a lower minimum detectable polarization, which is crucial for improving the sensitivity of detectors. ### Solution To solve the above problems, the researchers analyzed the charge distribution of the GSENSE2020BSI CMOS detector and proposed a two - dimensional segmentation method to distinguish between signals and noise based on the charge distribution. This method is implemented through the following steps: 1. **Dataset Construction**: A mixed dataset (including all single - pixel and multi - pixel events) and a noise dataset (also including all single - pixel and multi - pixel events) were created. 2. **Two - Dimensional Distribution Map**: Using the central pixel value as the x - axis parameter and the sum of the other eight pixel values as the y - axis parameter, a two - dimensional distribution map was drawn. 3. **Dividing Line Selection**: The initial dividing line \(y = - 1.9x+130\) was selected empirically, and the events above the dividing line were regarded as signals, and the events below were regarded as noise. 4. **Performance Evaluation**: The performance of the method was evaluated using the Figure of Merit (FOM), and the maximum FOM values under different characteristic parameters were calculated. The results showed that when the sum of the second and third largest pixel values (SPTV) was used as the characteristic parameter, the FOM value was the highest, indicating that this method has the best signal - to - noise discrimination ability. ### Results and Discussion The experimental results showed that the proposed two - dimensional segmentation method can effectively reduce the low - energy threshold of the G2020BSI detector, with almost no signal loss, and significantly improve the signal - to - noise ratio of low - energy X - ray events. In addition, this method is not sensitive to the selection of characteristic parameters, and good results can be obtained even when using empirically selected parameters. ### Conclusion This study proposed a new noise discrimination method based on charge distribution, which is suitable for the detection of low - energy soft X - ray events. This method not only improves the signal - to - noise ratio, but also has almost no signal loss, and has broad application prospects. Future research will further verify the applicability of this method in other types of detectors.

Noise discrimination method based on charge distribution of CMOS detectors for soft X-ray

New Method for Optimizing the Detection of Low-Energy Soft X-rays (200–300 Ev) in a CMOS Detector

An investigation of γ radiation detection with a CMOS imaging sensor

Temporal Noise Analysis of Charge-Domain Sampling Readout Circuits for CMOS Image Sensors

Material Discrimination Study of Dual-Energy Imaging Using Photon Counting Detector

Simulation Study of the Neutron–gamma Discrimination Capability of a Liquid Scintillator Neutron Detector

n-γ discrimination in low energy region using Artificial Neural Network based on improved traditional methods

A Study of $\delta\sigma$ -CDS Algorithm for X-Ray CCD Applications

CdTe Based Energy Resolving, X-ray Photon Counting Detector Performance Assessment: The Effects of Charge Sharing Correction Algorithm Choice

Research on multi-spectrum detector in High-energy dual-energy X-ray imaging system

Particle Detector Readout Integrated Circuit of 0.18 Mu M Technology with 164 E Equivalent Noise Charge

The impact of bias row noise to photometric accuracy: case study based on a scientific CMOS detector

A novel measurement method for SiPM external crosstalk probability at low temperature

MSE/SSE Discrimination Methods of the PC-HPGe Detector

Demonstrating sub-electron noise performance in Single electron Sensitive Readout (SiSeRO) devices

Insight into the Impact of Electron Drift Trajectory on Charge Collection in Silicon Drift Detector

Improving the X-ray energy resolution of a scientific CMOS detector by pixel-level gain correction

The Digital discrimination of neutron and γ ray using organic scintillation detector based on wavelet transform modulus maximum

Design and test results of scientific X-ray CMOS cameras

Study on the Sequential Bayesian Approach for a CsI(Tl)-based Radioactive Material Detection System