Abstract:Cosmic microwave background (CMB) experiments have deployed focal planes with transition edge sensor (TES) bolometers cooled to sub-Kelvin temperatures by multiplexing the readout of many TES channels onto a single pair of wires. Digital Frequency-domain Multiplexing (DfMux) is a multiplexing technique used in many CMB polarization experiments, such as the Simons Array, SPT-3 G, and EBEX. The DfMux system studied here uses LC filters with resonant frequencies ranging from 1.5 to 4.5 MHz connected to an array of TESs. Each detector has an amplitude-modulated carrier tone at the resonant frequency of its accompanying LC resonator. The signal is recovered via quadrature demodulation where the in-phase (I) component of the demodulated current is in phase with the complex admittance of the circuit and the quadrature (Q) component is orthogonal to I. Observed excess current noise in the Q component is consistent with fluctuations in the resonant frequency. This noise has been shown to be non-orthogonal to the phase of the detector's responsivity. We present a detailed analysis of the phase of responsivity of the TES and noise sources in our DfMux readout system. Further, we investigate how modifications to the TES operating resistance and bias frequency can affect the phase of noise relative to the phase of the detector responsivity, using data from Simons Array to evaluate our predictions. We find that both the phase of responsivity and phase of noise are functions of the two tuning parameters, which can be purposefully selected to maximize signal-to-noise (SNR) ratio.

Monitoring TES Loop Gain in Frequency Multiplexed Readout

Monitoring TES Loop Gain in Frequency Multiplexed Readout

A Method of Measuring TES Complex ETF Response in Frequency-domain Multiplexed Readout by Single Sideband Power Modulation

Operation of transition edge sensors in a resistance locked loop

Improved Performance of TES Bolometers using Digital Feedback

Frequency division multiplexing readout of a transition edge sensor bolometer array with microstrip-type electrical bias lines

Frequency domain multiplexing readout for large arrays of transition-edge sensors

Multiplexed readout demonstration of a TES-based detector array in a resistance locked loop

A multiplexer for the ac/dc characterization of TES based bolometers and microcalorimeters

Frequency shift algorithm: Design of a baseband phase locked loop for frequency-domain multiplexing readout of x-ray transition-edge sensor microcalorimeters

Simulation and Measurement of Out-of-Band Resonances for the FDM Readout of a TES Bolometer

Understanding the Phase of Responsivity and Noise Sources in Frequency-Domain Multiplexed Readout of Transition Edge Sensor Bolometers

The Simons Observatory: Differentiating Thermal and Optical Effects in Superconducting Transition-Edge Sensing Bolometers

Performance of an X-ray single pixel TES microcalorimeter under DC and AC biasing

Developments on Frequency Domain Multiplexing Readout for Large Arrays of Transition-Edge Sensor X-ray Micro-calorimeters

The Simons Observatory: Large-Scale Characterization of 90/150 GHz TES Detector Modules

Calibration and Testing of Small High-Resolution Transition Edge Sensor Microcalorimeters with Optical Photons

MNTES: Modeling Nonlinearity of TES detectors for Enhanced Cosmic Microwave Background measurements with LiteBIRD

Development of frequency domain multiplexing for the X-ray Integral Field Unit (X-IFU) on the Athena