What problem does this paper attempt to address?

The focus of this paper is on accurately modeling and controlling the gain characteristics of Erbium-Doped Fiber Amplifiers (EDFAs), particularly in the context of full-spectrum load conditions. The author proposes a two-step measurement-based gain profile model to more accurately simulate the behavior of EDFA, including gain ripple. In practical operation, the gain and tilt parameters of EDFA are crucial for finding the optimal operating point of the system. The paper first introduces the importance of Quality of Transmission (QoT) estimation in optimizing optical network capacity, especially for predicting system behavior. The existing open-source GNPy model has been widely validated but needs to consider the frequency-dependent description of physical layer parameters, particularly for wideband transmission scenarios. The approach of the paper is to design the gain profile of EDFA through dynamic gain tilt (DGT) parameters and define a constant parameter that is independent of specific tilt and gain settings. By using machine learning strategies from existing works, it is possible to compensate for gain ripple caused by different spectral loads. The paper presents a semi-analytical EDFA model that accurately estimates the gain profile for any gain/tilt setting by characterizing it under full-spectrum load conditions using only two gain/tilt settings. This approach has low computational cost and high accuracy, making it suitable for efficient QoT estimation tools like GNPy. In the experimental section, the paper comprehensively characterizes two series of EDFAs from different suppliers and verifies the proposed model. The results show that the model can accurately estimate the gain profile, with errors concentrated around 0 dB, indicating the unbiasedness and effectiveness of the model. In conclusion, the paper proposes a simple and accurate two-step EDFA gain profile modeling method suitable for full-spectrum load conditions, which has been experimentally validated on different vendor equipment. The characterization process of EDFA is simplified by evaluating the gain profile of all combinations of input power, gain, and tilt values using only two gain profile samples. This approach is applicable to both suppliers and end users.

Gain profile characterization and modelling for an accurate EDFA abstraction and control

Modeling EDFA Gain: Approaches and Challenges

Building a digital twin of EDFA: a grey-box modeling approach

Building a Digital Twin of an EDFA for Optical Networks: a Gray-Box Modeling Approach

Study on noise figure and gain of EDFA

EDFA Gain Optimization for WDM System

Characteristics of the bandwidth in gain-clamped erbium-doped fiber amplifiers

ERBIUM DOPED FIBER AMPLIFIER USING FIBER BRAGG GRATINGS AS GAIN EQUALIZER

The Characteristic Investigation of Gain-clamped EDFA

Improvement of gain and noise figure in double-pass L-band EDFA by incorporating a fiber Bragg grating

Improving Modal Gain Equalization for Few-Mode EDFA Enabled by Mode Routing Optimization

A Comprehensive Analysis on Machine Learning Based EDFA Gain Model

An Erbium-Doped Fiber Amplifier With Tunable Gain-Clamping in the Extended L-Band

DSP-based Link Tomography for Amplifier Gain Estimation and Anomaly Detection in C+L-band Systems

Tunable, gain clamped double pass Erbium doped fiber

Simple model for the erbium-doped fiber amplifiers (EDFA)

Dynamically Gain Control in the Serial Structure&gt;tex&lt;$C+L$&gt;/tex&lt;Wide-Band EDFA

Gain Equalization of EDFA Using a Loop F Ilter with a Single Polarization Controller

A simple control algorithm for wide-band channel-power clamped EDFA

An Optimization Algorithm for Optical Gain in the Multi-EDFAs-based Fiber-optic Time Synchronization

Multi-band programmable gain Raman amplifier