Dense strontium hexaferrite-based permanent magnet composites assisted by cold sintering process

Eduardo García-Martín,Cecilia Granados-Miralles,Sandra Ruiz-Gómez,Lucas Pérez,Adolfo del Campo,Jesús Carlos Guzmán-Mínguez,César de Julián Fernández,Adrián Quesada,José F. Fernández,Aida Serrano

DOI: https://doi.org/10.1016/j.jallcom.2022.165531

2023-09-25

Abstract:The use of rare-earth-based permanent magnets is one of the critical points for the development of the current technology. On the one hand, industry of the rare-earths is highly polluting due to the negative environmental impact of their extraction and, on the other hand, the sector is potentially dependent on China. Therefore, investigation is required both in the development of rare-earth-free permanent magnets and in sintering processes that enable their greener fabrication with attractive magnetic properties at a more competitive price. This work presents the use of a cold sintering process (CSP) followed by a post-annealing at 1100 °C as a new way to sinter composite permanent magnets based on strontium ferrite (SFO). Composites that incorporate a percentage < 10% of an additional magnetic phase have been prepared and the morphological, structural and magnetic properties have been evaluated after each stage of the process. CSP induces a phase transformation of SFO in the composites, which is partially recovered by the post-thermal treatment improving the relative density to 92% and the magnetic response of the final magnets with a coercivity of up to 3.0 kOe. Control of the magnetic properties is possible through the composition and the grain size in the sintered magnets. These attractive results show the potential of the sintering approach as an alternative to develop modern rare-earth-free composite permanent magnets.

Materials Science