Abstract:Permanent magnets (PM) are critical components for electric motors and power generators. Key properties of permanent magnets, especially coercivity and remanent magnetization, are strongly dependent on microstructure. Understanding metallurgical processing, phase stability and microstructural changes are essential for designing and improving permanent magnets. The widely used PM for the traction motor in electric vehicles and for the power generator in wind turbines contain rare earth elements Nd and Dy due to their high maximum energy product. Dy is used to sustain NdFeB's coercivity at higher temperature. Due to the high supply risk of rare earth elements (REE) such as Dy and Nd, these elements are listed as critical materials by the U.S. Department of Energy and other international institutes. Other than Dy, finer grain size is also found to have effect on sustaining coercivity at higher temperature. A proper control of phase stability and microstructures has direct impact on mitigating REE supply risk. Compared to rare earth PMs, non-rare earth (non-RE) PMs typically have lower maximum energy products, however, given their small supply risks and low cost, they are being intensively investigated for less-demanding applications. The general goal for the development of non-RE PMs is to fill in the gap between the most cost-effective but low performing hard ferrite magnet and the most expensive but high performing RE PMs. In the past five years great progress has been made toward improving the microstructure and physical properties of non-RE PMs. Several new candidate materials systems were investigated, and some have showed realistic potential for replacing RE PMs for some applications. In this article, we review the science and technology of various types of non-RE materials for PM applications. These materials systems include Mn based, high magnetocrystalline anisotropy alloys (MnBi and MnAl compounds), spinodally decomposing alloys (Alnico), high-coercivity tetrataenite L10 phase (FeNi and FeCo), and nitride/carbide systems (such as α" based, high saturation magnetization Fe16N2 type phase and Co2C/Co3C acicular particle phase). The current status, challenges, potentials as well as the future directions for these candidates non-RE magnet materials are discussed.

On the potential of hard ferrite ceramics for permanent magnet technology -- a review on sintering strategies

Permanent Magnets Based on Hard Ferrite Ceramics

Hexaferrite-based permanent magnets with upper magnetic properties by cold sintering process via a non-aqueous solvent

Greener processing of SrFe$_{12}$O$_{19}$ ceramic permanent magnets by two-step sintering

Dense strontium hexaferrite-based permanent magnet composites assisted by cold sintering process

Manufacturing Processes for Permanent Magnets: Part I—Sintering and Casting

Current Progress and Future Challenges in Rare-Earth-free Permanent Magnets

The physical metallurgy and processing of sintered rare earth permanent magnets

Prospect and status of iron-based rare-earth-free permanent magnetic materials

Recent developments in hard magnetic bulk materials

Perspectives on Permanent Magnetic Materials for Energy Conversion and Power Generation

Recent Research Trend in Powder Process Technology for High-Performance Rare-Earth Permanent Magnets

Recent Developments in 3D Printing of Rare-Earth-Free Permanent Magnets

On the relation between performance and permanent demagnetisation in spoke type machines with ferrite magnets

Material Formulation of Strontium Ferrite Permanent Magnets from Phase Diagrams and Microstructures

Magnetic Materials and Devices for the 21st Century: Stronger, Lighter, and More Energy Efficient

Micromagnetics of rare-earth efficient permanent magnets

High-performance Permanent Magnets for Efficient Energy Conversion: A Review on the Development of Grain-boundary Diffusion

Exploring Sintered Fe-(Ce, Nd)-B with High Degree of Cerium Substitution as Potential Gap Magnet

Co–Al-substituted strontium hexaferrite for rare earth free permanent magnet and microwave absorber application

New Developments in NdFeB-Based Permanent Magnets