Abstract:Calculating wind resistance is an important process in the design of highway bridges. The current codes of many countries include different rules and formulas regarding the calculation of wind resistance. In this paper, the transverse-direction wind loads on long-span girder bridges with tall piers were calculated using six codes from different countries under various terrain, pier height, and girder length conditions. The pier-bottom shear force and moment results of transverse wind loads calculated using these six codes were compared with those obtained using the buffeting frequency domain method. Results showed that, in Class B terrain, wind load results predicated on China's 2004 general codes for the design of highway bridges and culverts, China's 2004 wind-resistant design specifications for highway bridges, Japan's 2007 wind-resistant design manual for highway bridges, and Part 2 of Britain's 2006 steel, concrete, and composite bridge specifications for loads resembled each other closely. Some difference was found to exist among Classes A, C, and D terrain. The 2007 AASHTO LRFD bridge design specifications and China's 2001 load codes for the design of building structures showed significant differences from the other four codes on all kinds of terrain. The applicability of the wind load rules in the AASHTO LRFD bridge design specifications to long-span girder bridges with tall piers merits further discussion. China's wind load calculations of load code for the design of building structures mainly depended on the empirical parameters of architectural structures with large dimensions, and had limited applicability to bridge structures. For long-span girder bridges with tall piers, such as bridges with span length-to-width or -depth ratios exceeding 30, or pier height-to-transverse-width ratio exceeding 10.7, the wind load calculated using these codes was generally underestimated due to the neglect of the effects of aeroelastic forces, which must be taken into account in the design of these kinds of bridges. DOI: 10.1061/(ASCE)BE.1943-5592.0000316. (C) 2012 American Society of Civil Engineers.

Inconsistencies between the forces from code live load models and real traffic on truss bridges

Numerical evaluation of code live-load models for estimating the forces caused by actual vehicles that act on bridge substructures

DESIGN PROCEDURES FOR FOOTBRIDGES SUBJECTED TO WALKING LOADS: COMPARISON AND REMARKS

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Fatigue Performance Assessment of Composite Arch Bridge Suspenders Based on Actual Vehicle Loads

Site-Specific Fatigue Load Spectrum for Urban Bridges

FE-based Bridge Weigh-in-motion Based on an Adaptive Augmented Kalman Filter

Bridge Vehicle Load Model on Different Grades of Roads in China Based on Weigh-in-Motion (WIM) Data

Vehicle Load Effect of Long-Span Bridges

Methods of calculating wind loads on long-span girder bridges with tall piers and comparison of values

Analysis and Comparison on Wind Load of Long Span Girder Bridges with High Pier

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

Model Updating Concept Using Bridge Weigh-in-Motion Data

Dynamic Analysis Techniques for Road Bridges Under Large Traffic Flows

Comparative Study on the Methods for Analyzing Transverse Intemal Force of Prestressed Concrete Box Girder Bridge

Comparison of Different Modeling Approaches and Their Influence on the Dynamic Calculation of Four Single-Span Railway Bridges

Statistical Analysis of Site-specific Traffic Load Using Weigh-in-Motion Data

Bridge Load Testing for Identifying Live Load Distribution, Load Rating, Serviceability and Dynamic Response

Moving load effect on a bridge

Theoretical and computational simulation of the effect of the number of intermediate diaphragms on the live load distribution factors and structural response of a precast girder bridge

WIM-based vehicle load models for urban highway bridge