Abstract:For future investigations of strongly coupled plasmas with electron temperature above the Fermi temperature, Ne near solid density and the electron-electron coupling paramter Γee > 1, there is a need for new diagnostics. This matter has such a low temperature, that emission spectroscopy is not possible and probing with visible or UV-light is also impossible as it cannot penetrate the plasma due to the corresponding low critical electron density. One possibility to elude this problem is spectrally resolved x-ray scattering, which can be realized by the kilojoule PHELIX-laser as the driver for the x-ray source. Spectrally resolved x-ray scattering potentially provides both electron density and temperature from the red-shifted line-wings of the scattered radiation [1]. For these purposes it is important to know the underlying satellite structure in this wings. A future probing beam could be the Heα-resonance line of chlorine with a wavelength of λ = 0.4444 nm. A high-reflectivity Bragg-crystal spectrometer is needed to resolve this scattered radition. Here highly oriented pyrolytic graphite (HOPG, 2d = 6.708 Å) [2] seems to be a good candidate. Due to its rockingcurve the spectral resolution of the crystal is about 500. Unfortunately one cannot resolve the dielectronic structure that is underlying the probing Heα-transition radiation. To investigate the influence of these satellites on the spectrum of the source and to calibrate this spectrometer we used a focusing spectrometer with spatial resolution (FSSR) [3] with a spherically bent mica crystal (2d = 19.915 Å, R = 150 mm, λ/∆λ up to 10000) in a FSSR-1D scheme. The x-rays were recorded with Kodak DEF-5 films. With this set-up one can get the characteristics of the source with high spectral resolution and determine experimentally the blended transitions of the HOPG-spectrum. We used the chlorine Heα-line to calibrate a newly developed flat HOPG-spectrometer with the FSSR. The radiation was produced by illuminating massive PVC targets with the NHELIX laser beam (Nd:YAG, energy up to 140 J in 14 ns). The spectrometers were placed at a distance of 22.7 cm (FSSR) and 13.6 cm (HOPG) on opposite sides of the target at an angle of ≈ 10◦ according to the surface.

Electron-beam Calibration of Aerogel Tiles for the HELIX RICH Detector

The High Energy Light Isotope eXperiment program of direct cosmic-ray studies

Developing a silica aerogel radiator for the HELIX ring-imaging Cherenkov system

Performance of a Quintuple-GEM Based RICH Detector Prototype

Calibration and Testing of Small High-Resolution Transition Edge Sensor Microcalorimeters with Optical Photons

A Cherenkov Radiation Detector With High Density Aerogels

2 Investigation laser-produced chlorine plasmas for x-ray scattering experiments

Scintillator Tile Batch Test of CEPC AHCAL

Energy calibration of high-resolution X-Ray TES microcalorimeters with 3 eV optical photons

Calibration of the instrumental response of Insight-HXMT/HE CsI detectors for gamma-ray monitoring

Development Of Wavelength Calibration Techniques For High-Resolution X-Ray Imaging Crystal Spectrometers On The East Tokamak

A Calibration System for Compton Polarimetry at $e^+e^-$ Linear Colliders

Improved Calibration of the OMEGA Gas Cherenkov Detector.

Development of a low-pressure Multi-Mesh THGEM detector for fission experiments at FRIB

Characterization of an Ionization Readout Tile for Nexo

Background Measurements from Balloon-Borne CZT Detectors

Radioactive Source Calibration Technique for the CMS Hadron Calorimeter

Solid Cherenkov Detector for Studying Nucleosynthesis in Inertial Confinement Fusion

Imaging effects due to pixel distortions in CdZnTe (CZT) detectors -- results from the HREXI Calibration Facility (HCF)

arXiv : Test beam results of a Cylindrical GEM detector for the BESIII experiment