Abstract:<p>Quantitative characterization of subsurface defects is a challenging problem in eddy current testing (ECT), not only due to the limitation of the penetration depth of eddy currents, but also due to the ill-posed nature of the inverse problem associated with quantifying a defect's 3D dimensions and its location in the test sample from measurements made on the sample surface. This paper presents a new ECT method for subsurface defect detection and quantification. Eddy currents with continuously varying frequency in a selected frequency band is induced in the conductive sample by using a chirp modulated excitation scheme. The frequency band of the chirp waveform is chosen so that the penetration depth of eddy current in the selected frequency band covers the thickness of the sample under test. The presence of a defect will disturb the distribution of the induced eddy currents. This disturbance is measured in terms of a varying magnetic field using an array of tunneling magneto-resistance (TMR) sensors. A C-scan image is obtained by linearly scanning the specimen. The footprint of the defect is calculated using spatial features of the C-scan image while the depth of the defect is estimated by analyzing the frequency characteristics of the measured chirp signal. A three-dimensional estimate of the dimensions of any subsurface defect can be obtained using the empirical procedure. The operating principle of this method is studied with a finite element method (FEM) model and then validated experimentally with a prototype array probe consisting of 180 TMR sensors. Thanks to its high sensitivity, the TMR sensors are suitable for measuring the weak low frequency magnetic field signal caused by a deep defect. The spacing between each two adjacent sensors is as small as 0.5 mm providing a magnetic field image with fine spatial resolution, which is beneficial for defect quantification. An aluminum sample with embedded defects was tested using the prototype probe. It is seen that the proposed scheme utilizing spatial and frequency domain features is capable of quantitatively characterizing subsurface defects.</p>

Defect Localization in Flip-Chip Devices Using Space-Domain Reflectometry and Magnetic Current Imaging

High-Resolution Short-Circuit Fault Localization in a Multi-Layer Integrated Circuit using a Quantum Diamond Microscope

A 3-D Pseudo Magnetic Flux Leakage (PMFL) Signal Processing Technique for Defect Imaging

Overview of Defect Magnetic Flux Leakage Imaging Technology

Vector Magnetic Current Imaging of an 8 nm Process Node Chip and 3D Current Distributions Using the Quantum Diamond Microscope

High-resolution Magnetic Imaging Probe with Staggered Sensor Arrays for Small Defects Inspection

A 3-D Imaging Method for Local Shallow Defects on the Surface of Ferromagnetic Materials

A Novel Defect Quantification Method Utilizing Multi-Sensor Magnetic Flux Leakage Signal Fusion

An improved method for test chip design

Bounds on Distinguishing Separated Wires Using Magnetic Field Measurements

Deep Defects Evaluation of Conductive Materials Based on Eddy Current Nondestructive Testing with GMR sensor

Image Intensity Analysis For Defect Localization Utilizing Sem Bse Imaging

Magnetic Field Fingerprinting of Integrated Circuit Activity with a Quantum Diamond Microscope

Quantitative Nondestructive Estimation of Deep Defects in Conductive Structures

Research on defect image inversion method based on multiple lift-off values magnetic memory signals

Sparse Magnetic Array for the Imaging of Defects in Multilayer Metals

An Improved MFL Method Fusing Multi-Space Magnetic Field Information for The Surface Defect Inspecting

An Opening Profile Recognition Method for Magnetic Flux Leakage Signals of Defect

Frequency domain analysis of magnetic field images obtained using TMR array sensors for subsurface defect detection and quantification

Magnetic Field-Based Eddy-Current Probe Design, Modeling, and Computing Methods for Edge Defect Detection

Physical coupling fusion sensing of MFL-EMAT for synchronous surface and internal defects inspection