Abstract:The commissioning of the upgrade project of the Beijing Electron Positron Collider (BEPCII) started on Nov. 12, 2006. During the 1 and 2 stages of the commissioning of the BEPCII rings, we had got the luminosity one tenth of its design value, provided beams to synchrotron radiation users for ~ 4 months, and studied beam dynamics as well. In this paper, some preliminary results of the beam dynamics will be given. INTRODUCTION The upgrade project of the Beijing Electron Positron Collider (BEPC), BEPCII, is mainly composed of a linac, two transport lines and two storage rings in parallel for eand e+ beams, respectively. The two halves of the outer rings are connected as a synchrotron radiation (SR) ring, with 14 beam lines extracted from 5 wigglers and 9 bending magnets. The layout and other details of the three rings of BEPCII can be found in [1]. In this paper, we mainly discuss some beam current dependent phenomena in the collision rings, say, BER and BPR for eand e+ beams, respectively. Some main nominal parameters of the lattice are listed in Table 1. Table 1: Main parameters of the BEPCII collision rings Beam energy GeV 1.89 Circumference m 237.53 Beam current A 0.91 Bunch current / Bunch No. mA 9.8 / 93 Natural bunch length mm 13.6 RF frequency MHz 499.8 Harmonic number 396 Emittance (x/y) nm.rad 144/2.2 β function at IP (x/y) m 1.0/0.015 Crossing angle mrad ±11 Tune (x/y/s) 6.54/5.59/0.034 Momentum compaction 0.0237 Energy spread 5.16×10 Natural chromaticity (x/y) −10.8/−20.8 Luminosity cms 1×10 Both BER and BPR have same magnetic lattices with the super period number of 1. Figure 1 shows the Twiss functions in the interaction region, the RF region and the whole ring. In order to have a big emittance and a high beam current, a quasi-FODO structure with 10 dipoles and 2 missing dipoles in each arc is applied. In the second section, we will discuss the single bunch beam dynamics studies. Multi-bunch beam effects will be introduced in section 3. Some instabilities were observed and showed in section 4. At last, a summary will be given. Figure 1: Twiss functions in the IR (up-left), the RF region (up-right) and the whole ring (down) of BER/BPR SINGLE BUNCH BEAM DYNAMICS Optics correction After beams were injected smoothly into the rings, the β functions along the rings are measured before and after the optics corrections based on the measured response matrices [2]. The relative errors between the nominal and measured beta functions are less then 10% averagely. Other Twiss functions, such as dispersions and transverse tunes, were also measured and close to the design values. Under these circumstances, we could do some beam observations and measurements of other parameter. Beam energy spread Beam energy spread was measured with the method of longitudinal quantum lifetime. If the RF voltage is set to keep a relatively short beam lifetime, say 20 or 30 min, thus the longitudinal quantum lifetime can be considered as the dominant one. The beam energy spread at different bunch current could be estimated with the longitudinal momentum acceptance. Figure 2 shows the beam energy spreads at different bunch current in both BER and BPR. 5.1 5.14 5.18 5.22 5.26 0 3 6 9 12 Ib(mA) σ (Ε −4 )

Luminosity performance of SuperKEKB

Luminosity performance of SuperKEKB

Simulations and experimental results on beam-beam effects in SuperKEKB

Beam Dynamics Issues in the SuperKEKB

Beam optics distortion caused by orbit deviation at strong sextupole magnets in SuperKEKB

Development and Implementation of Advanced Beam Diagnostic and Abort Systems in SuperKEKB

Design and construction of the SuperKEKB vacuum system

Beam injection and beam quality in injector LINAC and in beam transport lines at SuperKEKB

Future e+ e- Flavor Factories: accelerator challenges

Beam-beam studies for the High-Energy LHC

Formulae of luminosity and beam-beam tune shifts for flat-beam asymmetric colliders

Imperfections in the Crab-Waist Scheme

Impact of beam–beam effects on absolute luminosity calibrations at the CERN Large Hadron Collider

Beam-beam effects in BEPCII

Performance and luminosity models for heavy-ion operation at the CERN Large Hadron Collider

Impact of Beam-Beam Effects on Absolute Luminosity Calibrations at the CERN Large Hadron Collider

Studies on the beam current dependent phenomena in the bepc-ii storage rings

Super KEKB and Belle II: Status of the KEK Super B Factory

Luminosity for laser-electron colliders

Optimization of performance of the KM2A full array using the Crab Nebula

Energy deposition studies for the Upgrade II of LHCb at the CERN Large Hadron Collider