Abstract:Superconducting nanowire single photon detectors (SNSPDs) promise to combine near-unity quantum efficiency with >100 megacounts per second rates, picosecond timing jitter, and sensitivity ranging from x-ray to mid-infrared wavelengths. However, this promise is not yet fulfilled, as superior performance in all metrics is yet to be combined into one device. The highest single-pixel detection efficiency and the widest bias windows for saturated quantum efficiency have been achieved in SNSPDs based on amorphous materials, while the lowest timing jitter and highest counting rates were demonstrated in devices made from polycrystalline materials. Broadly speaking, the amorphous superconductors that have been used to make SNSPDs have higher resistivities and lower critical temperature (Tc) values than typical polycrystalline materials. Here, we demonstrate a method of preparing niobium nitride (NbN) that has lower-than-typical superconducting transition temperature and higher-than-typical resistivity. As we will show, NbN deposited onto unheated SiO2 has a low Tc and high resistivity but is too rough for fabricating unconstricted nanowires, and Tc is too low to yield SNSPDs that can operate well at liquid helium temperatures. By adding a 50 W RF bias to the substrate holder during sputtering, the Tc of the unheated NbN films was increased by up to 73%, and the roughness was substantially reduced. After optimizing the deposition for nitrogen flow rates, we obtained 5 nm thick NbN films with a Tc of 7.8 K and a resistivity of 253 μΩ cm. We used this bias sputtered room temperature NbN to fabricate SNSPDs. Measurements were performed at 2.5 K using 1550 nm light. Photon count rates appeared to saturate at bias currents approaching the critical current, indicating that the device's quantum efficiency was approaching unity. We measured a single-ended timing jitter of 38 ps. The optical coupling to these devices was not optimized; however, integration with front-side optical structures to improve absorption should be straightforward. This material preparation was further used to fabricate nanocryotrons and a large-area imager device, reported elsewhere. The simplicity of the preparation and promising device performance should enable future high-performance devices.

Site-Selective Enhancement of Superconducting Nanowire Single-Photon Detectors via Local Helium Ion Irradiation

Enhancing intrinsic detection efficiency of superconducting nanowire single-photon detectors via helium ion irradiation

Current-Crowding-Free Superconducting Nanowire Single-Photon Detectors

Bias Sputtered Nbn and Superconducting Nanowire Devices

Improvements of readout signal integrity in mid-infrared superconducting nanowire single-photon detectors

Improvements of readout signal integrity in mid-infrared superconducting nanowire single photon detectors

Sputtered NbN Films for Ultrahigh Performance Superconducting Nanowire Single-Photon Detectors

NbN Superconducting Nanowire Single-Photon Detector With 90.5% Saturated System Detection Efficiency and 14.7 ps System Jitter at 1550 nm Wavelength

Single-photon detection using high-temperature superconductors

Microfiber-coupled superconducting nanowire single-photon detector for near-infrared wavelengths.

Enhancing the Performance of Superconducting Nanowire-Based Detectors with High-Filling Factor by Using Variable Thickness

Enhancing SNSPDs detection efficiency via suspended SiO2 membrane

Self-aligned Multi-Channel Superconducting Nanowire Single-Photon Detectors.

Fabrication of Superconducting Nanowire Single-Photon Detector

Enhancement of optical response in nanowires by negative-tone PMMA lithography

Saturation efficiency for detecting 1550 nm photons with a 2 × 2 array of Mo<sub>08</sub>Si<sub>02</sub> nanowires at 22 K

Operation of Multi-Pixel Radio-Frequency Superconducting Nanowire Single-Photon Detector Arrays

Saturation efficiency for detecting 1550 nm photons with a 2 x 2 array of Mo<sub>0.8</sub>Si<sub>0.2</sub> nanowires at 2.2 K

Operation of parallel SNSPDs at high detection rates

High Efficiency, Large-Active-area Superconducting Nanowire Single-Photon Detectors

Minimal lateral damage fabrication of high-temperature superconducting nanowires via focused helium ion beam irradiation