Implementing Microwave Impedance Microscopy in a Dilution Refrigerator

Zhanzhi Jiang,Su Kong Chong,Peng Zhang,Peng Deng,Shizai Chu,Shahin Jahanbani,Kang Lung Wang,Keji Lai

DOI: https://doi.org/10.1063/5.0138831

2023-04-17

Abstract:We report the implementation of a dilution-refrigerator-based scanning microwave impedance microscope (MIM) with a base temperature of ~ 100 mK. The vibration noise of our apparatus with tuning-fork feedback control is as low as 1 nm. Using this setup, we have demonstrated the imaging of quantum anomalous Hall states in magnetically (Cr and V) doped (Bi, Sb)2Te3 thin films grown on mica substrates. Both the conductive edge modes and topological phase transitions near coercive fields of Cr-doped and V-doped layers are visualized in the field-dependent results. Our work establishes the experimental platform for investigating nanoscale quantum phenomena under ultralow temperatures.

Mesoscale and Nanoscale Physics

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to implement a Scanning Microwave Impedance Microscopy (MIM) based on a dilution refrigerator (DR) in order to study the nanoscale properties of quantum materials at extremely low temperatures (about 100 mK). Specifically, the authors designed and constructed a low - temperature MIM system equipped with tuning - fork feedback control, which can operate in a dilution refrigerator and has a topological noise as low as 1 nm. Through this system, they successfully imaged the quantum anomalous Hall state in magnetically - doped topological insulator materials ((Bi, Sb)₂Te₃ thin films) and observed the topological phase transition related to magnetization reversal. This work provides an experimental platform for studying quantum phenomena under ultra - low - temperature conditions.

### Main Objectives:
1. **Implement Low - Temperature MIM**: Develop an MIM system that can operate in a dilution refrigerator to achieve high - resolution imaging at extremely low temperatures.
2. **Reduce Vibration Noise**: By optimizing the system design, reduce the vibration noise to below 1 nm to ensure high - quality imaging results.
3. **Study Quantum Materials**: Use this system to image magnetically - doped topological insulators, especially to observe the quantum anomalous Hall state and topological phase transitions.

### Key Results:
- **System Design**: Describe in detail the experimental setup of the system, including vibration isolation, tuning - fork feedback control, microwave component configuration, etc.
- **Imaging Results**: Present the imaging results of magnetically - doped (Bi, Sb)₂Te₃ thin films at a temperature of about 100 mK, including the visualization of the quantum anomalous Hall state and topological phase transitions.
- **Performance Verification**: Verify the effectiveness and reliability of the system by comparing the transmission measurement and MIM imaging results.

### Significance:
This work not only provides a new experimental tool for studying the nanoscale properties of quantum materials at extremely low temperatures but also lays the foundation for further exploration of quantum phenomena such as the quantum Hall effect and topological insulators.