Phase transitions induced by standard and predetermined measurements in transmon arrays

Gonzalo Martín-Vázquez,Taneli Tolppanen,Matti Silveri
DOI: https://doi.org/10.1103/PhysRevB.109.214308
2024-03-29
Abstract:The confluence of unitary dynamics and non-unitary measurements gives rise to intriguing and relevant phenomena, generally referred to as measurement-induced phase transitions. These transitions have been observed in quantum systems composed of trapped ions and superconducting quantum devices. However, their experimental realization demands substantial resources, primarily owing to the classical tracking of measurement outcomes, known as post-selection of trajectories. In this work, we first describe the statistical properties of an interacting transmon array which is repeatedly measured, and predict the behavior of relevant quantities in the area-law phase using a combination of the replica method and non-Hermitian perturbation theory. We show numerically that a transmon array, modeled by an attractive Bose-Hubbard model, in which local measurements of the number of bosons are probabilistically interleaved, exhibits a phase transition in the entanglement entropy properties of the ensemble of trajectories in the steady state. Furthermore, by using deterministic feedback operations after the local number measurements, the distribution of the number of bosons measured at a single site carries information on the phase in the entanglement of individual trajectories. Interestingly, we can extract information about the phase and the phase transition from simple observables without considering an absorbing state in the feedback pattern. This implies that the feedback measurement approach might be a viable experimental option to use simple observables to study some aspects of the entanglement phase transition in individual trajectories.
Quantum Physics
What problem does this paper attempt to address?
The problem that this paper attempts to solve is about how to study measurement - induced phase transitions (MIPT) through standard measurements and feedback measurements in superconducting quantum processors (especially transmon arrays). Specifically, the authors explore the following issues: 1. **Experimental Realization of MIPT**: Traditional MIPT research relies on classical tracking of measurement results, namely the so - called post - selection of trajectories, which requires a large amount of resources. Therefore, this paper aims to explore a method that does not require explicit post - selection to study MIPT. 2. **Statistical Properties and Phase - Transition Behaviors**: The authors describe the statistical properties of an interacting transmon array under repeated measurements and predict the behaviors of relevant quantities in the area - law phase. They use the replica method and non - Hermitian perturbation theory to make this prediction. 3. **Influence of Feedback Measurements**: By introducing deterministic feedback operations, the authors study the phase - transition behaviors of the system after local particle - number measurements. They find that feedback measurements can provide information about the entanglement phase - transition of a single trajectory without considering the absorbing state. 4. **Application of Simple Observables**: The authors propose that information about the critical parameters of the entanglement phase - transition can be indirectly obtained through simple observables (such as the particle - number distribution at a single site). This method avoids the complex post - selection process and simplifies the experimental design. ### Specific Problem Analysis - **Measurement - Induced Phase Transitions**: MIPT refers to the phase transitions that occur in a quantum system when it is affected by measurements. Such phase transitions usually occur in hybrid circuits, which contain unitary evolution and non - unitary measurements. Frequent measurements can cause the system to change from volume - law entanglement to area - law entanglement. - **Standard Measurements vs Feedback Measurements**: Standard measurements can produce multiple possible trajectories, and each trajectory corresponds to a measurement result. Feedback measurements, on the other hand, apply a unitary operation that depends on the measurement result after each measurement, thereby collapsing all possible trajectories into a specific state. Feedback measurements can provide more statistical information and are helpful for more accurately estimating the critical point of the phase transition. - **Simplifying Experimental Complexity**: By using feedback measurements, the authors show how to use simple observables (such as the particle - number distribution at a single site) to study MIPT without performing complex post - selection. This not only simplifies the experimental design but also improves the feasibility and efficiency of the experiment. ### Conclusion The main contribution of this paper is to propose a new method to study MIPT in quantum systems through feedback measurements and simple observables, thus avoiding the complex post - selection process required in traditional methods. This method provides new ideas and technical means for future implementation and study of MIPT in superconducting quantum processors.