Abstract:Telecommunication system is one of the critical lifeline systems for national life and post-earthquake emergency response. Telecommunication equipment is the necessary components to preserve communication functionality of telecommunication system. The severe damage and functionality loss of data center buildings resulting from damage to telecommunication equipment are frequently reported following earthquakes. Thus, there is an increasing need to understand the performance of telecommunication equipment during earthquakes. Seismic investigation of three server cabinets in internet data center buildings are presented in this study. The seismic damage and dynamic characteristics of server cabinets were evaluated and explained in terms of the natural frequency, stress, acceleration, dynamic amplification factor, and deformation by triaxial shaking table tests. The input acceleration time histories were generated based on the required response spectra in YD 5083 code and AC 156 code, with seismic intensities ranging from 0.1 g to 1.2 g. Based on the test results, the effects of different mass distributions inside the cabinets and earthquake inputs were investigated. The seismic damage limit states of server cabinets were identified based on observed damage phenomenon. The corresponding seismic fragility models of server cabinets were developed based on shaking table test data. The results show that the Power Distribution Units inside the cabinets still worked normally and the output voltage was normal for all loading cases although the frame of cabinets suffered severe seismic damage. The normal functionality of server cabinets including more electronic devices and equipment should be carefully checked by shaking table tests.

Earthquake Simulation Shaking Table Testing of Class 1E Emergency Diesel Generator's Model Windings

Assessment of the Peak Response of a 5MW HAWT under Combined Wind and Seismic Induced Loads

Numerical Model of Cumulative Damage Evolution of Offshore Wind Turbine Grouted Connection under Cyclic Axial Load

Experimental and numerical study on dynamic response of offshore wind turbine subjected to earthquake loads

Dynamics of a High-voltage Switchgear System Excited by Earthquake

De-Excitation Simulation of 1 000 MW Steam-turbine Generator after Abrupt Three-phase Short Circuit

Dielectric Test Standard Discussion of 1 000 MW Generator Stator Winding in Nuclear Power Plant

Dynamic model test on monopile for offshore wind turbine under jointed lateral environmental load and seismic load

Seismic Performance Analysis of Emergency Diesel Engine Retarder in Nuclear Power Plant

Shaking Table Test and Numerical Analysis of a Coal-Fired Power Plant Equipped with Large Mass Ratio Multiple Tuned Mass Damper (LMTMD)

Loading Methodology and Dynamics Analysis of the Digital-Servo Hydraulic Cylinders Group in Large Wind Turbine Drivetrain Test Bench

Joint Earthquake and Wave Action on the Monopile Wind Turbine Foundation: an Experimental Study

Nonlinear Time History Analysis of a Pre-Stressed Concrete Containment Vessel Model under Japan's March 11 Earthquake

Seismic Damage Detection of A Full-Scale Shaking Table Test Structure

Shaking table tests of offshore wind turbine systems with a suction bucket foundation in sandy seabed subject to earthquake and wind loads

Shaking table test on seismic responses of a wind turbine tower subjected to pulse-type near-field ground motions

Evaluation of seismic response of server cabinets through shaking table tests

Shaking Table Test and Numerical Simulation On Seismic Behavior of a Receiver Tower in Concentrated Solar Power Plant Under Vertical Earthquake

Sensitivity Analysis of Seismic Behavior of Nuclear Power Plant Electrical Building

Seismic testing and fragility analysis considering material strength uncertainty of 1100 kV GFRP composite power transformer bushing

Partial Discharge Test for 1000 MW Nuclear Power Generator