Effect of NaCl on nitrate removal from ion-exchange spent brine in the membrane biofilm reactor (MBfR)

Steven W Van Ginkel,Bi-o Kim,Ziming Yang,Robby Sittmann,Mark Sholin,Joe Micelli,Bruce E Rittmann
DOI: https://doi.org/10.2166/wst.2011.832
Abstract:The H(2)-based membrane biofilm reactor was used to remove nitrate from synthetic ion-exchange brine at NaCl concentrations from ∼3 to 30 g/L. NaCl concentrations below 20 g/L did not affect the nitrate removal flux as long as potassium was available to generate osmotic tolerance for high sodium, the H(2) pressure was adequate, and membrane fouling was eliminated. Operating pHs of 7-8 and periodic citric acid washes controlled membrane fouling and enabled reactor operation for 650 days. At 30 psig H(2) and high nitrate loading rates of 15 to 80 g/m(2) d, nitrate removal fluxes ranged from 2.5 to ∼6 g/m(2) d, which are the highest fluxes observed when treating 30 g/L IX brine. However, percent removals were low, and the H(2) pressure probably limited the removal flux.
What problem does this paper attempt to address?