Abstract:An initial high fluence campaign was performed in WEST, in 2023, on the newly installed actively cooled tungsten divertor composed of ITER-grade monoblocks. The campaign consisted in the repetition of a 60 s long Deuterium L-mode pulse in attached divertor conditions, cumulating over 10000s of plasma exposure. A maximum deuterium fluence of approximately 5⋅1026 m −2 was reached in the outer strike point region, representative of a few high performance ITER pulses. Gross tungsten erosion inferred from visible spectroscopy shows that the most eroded plasma facing component is the inner divertor target with rates ten times larger than on the outer divertor target. The outer midplane tungsten bumpers, located a few centimeters from the plasma, show gross erosion rates two times lower than at the outer divertor. We conclude that the outer midplane bumpers have a negligible contribution to the long range tungsten migration and deposition onto the lower divertor. The cumulated gross erosion rate on the inner divertor translates in an effective gross erosion thickness of about 20μm , while it is about 2μm for the outer divertor. Strikingly, these orderings coincide with the thickness of deposits found locally on the divertor : the exposed surfaces of high field side monoblocks are covered with several tens of μm tungsten deposits, while on the lower field side, few μm thin tungsten deposits are only found on the magnetically shadowed parts of monoblocks. The strong impact of those deposits on WEST operation, namely perturbation of surface temperature measurement with infra-red thermography, and the emission of flakes causing radiative perturbation of the confined plasma, calls for anticipating similar issues in ITER. In particular, the start of research operation shall consider the definition of a divertor erosion budget in order to anticipate the formation of deleterious deposits.

Wall cratering upon high velocity normal dust impact

Normal high velocity solid dust impacts on tiles of tokamak-relevant temperature

Experimental and Numerical Simulations of ELM-like Transient Damage Behaviors to Different Grade Tungsten and Tungsten Alloys

High-velocity dust impacts in plasma facing materials: Insights from Molecular Dynamics Simulations

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Investigation into the erosion damage mechanism of High-Temperature, High-Pressure, and High-Speed gasflow on metal surfaces

Numerical Study of Solid Particle Erosion in a Cavity with Different Wall Heights

Drop impact on a heated wet wall: deposition-on-crater regime

Erosion Characteristics of Molten Aluminum Droplets Bouncing off Solid Walls in Solid Rocket Motors

Simulation of Erosion of the Tungsten Wall by Impurities in the Divertor Plasma

Impact of helium and hydrogen plasma exposure on surface damage and erosion of tungsten

The influence of impurities on the erosion of tungsten by low energy high flux deuterium plasma irradiation

Erosion dynamics of tungsten fuzz during ELM-like heat loading

Surface Damage and Structure Evolution of Recrystallized Tungsten Exposed to Elm-Like Transient Loads

Survey of tungsten gross erosion from main plasma facing components in WEST during a L-mode high fluence campaign

Surface erosion of materials induced by fast neutron sputtering

Thermal Damage of Tungsten-Armored Plasma-Facing Components under High Heat Flux Loads

Damaging Impacts of Energetic Charge Particles on Materials in Plasma Energy Explosive Events

Effects of Erosion Surface on Near Wall Conductivity (NWC) in the Hall-type Stationary Plasma Thrusters

Evolution of tungsten degradation under different cyclic ELM-like high heat flux plasma

Metallography and mechanical parameters of plasma-exposed plasma-facing materials and components