Abstract:Offshore wind power generation equipped with conventional grid following controls challenges the power system stability by reducing the inertia of the grid and weakening the AC offshore grid. To overcome this vulnerability a promising solution could be equipping the wind turbines with grid-forming (GFM) control schemes. Many methodologies have been presented in the literature for GFM inverters. In spite of this, their applications for WTGs have not been thoroughly explored. This paper presents the study of fault handling capability of wind turbines with several grid-forming control strategies. In this context, four different control schemes i.e. Visynch, P/f droop, Q/f droop and conventional grid following control are considered. The performance of these control strategies is assessed and compared during a three-phase symmetrical fault on the point of common coupling of an offshore wind farm. A case study which consists of two wind turbines connected to the main converter of an offshore substation equipped with grid-forming control is also considered. The results indicate that, during faults, each of the four control strategies (Visynch, P/f droop, Q/f droop, and Gfol) effectively limits the current and restores normal operation. A significant advantage of Q/F droop control is its reduced sensitivity to variations in system and fault parameters, adjustable frequency response, and independence from existing Phase-Locked Loops (PLLs). On the other hand, the P/f droop control provides greater voltage support during faults due to its voltage controllers. However, post-fault oscillations result from the stiff voltage controller. Visynch control, on the other hand, shows a lower margin of stability. The advantages and weaknesses of each control scheme is revealed using the simulation results.

Grid-Forming Inverter-based Wind Turbine Generators: Comprehensive Review, Comparative Analysis, and Recommendations

Small Signal Stability Analysis and Control of the Wind Turbine with the Direct-Drive Permanent Magnet Generator Integrated to the Grid

Grid Forming Converters in Renewable Energy Sources Dominated Power Grid: Control Strategy, Stability, Application, and Challenges

Grid‐forming control for inverter‐based resources in power systems: A review on its operation, system stability, and prospective

Transient Stability Analysis and Coordination Control Design for Grid-Forming PMSG Based on Dynamics of DC-Link Capacitor

Grid-Forming Control for DFIG Based Wind Farms to Enhance the Stability of LCC-HVDC

Control Method for Fault Ride-through of DFIG-based Wind Turbines Applied to Weak Grids

Reviewing Control Paradigms and Emerging Trends of Grid-Forming Inverters—A Comparative Study

Grid-Forming Converters: Control Approaches, Grid-Synchronization, and Future Trends—A Review

Grid-Forming Control Methods for Weakly Connected Offshore WPPs

A Review of Recent Requirements for Inverter-Based Resources and Grid-Forming Technologies

Fault Handling Capabilities of Grid-Forming Wind Turbines in Offshore Wind Farms Connected With MMC HVDC System

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Extended Characteristics of Grid-Forming Control: Seen from the Perspective of AC Power Supply

Oscillations between Grid-Forming Converters in Weakly Connected Offshore WPPs

An Improved Grid-Forming Control Strategy of Wind Turbine Generators with the Supercapacitor for Optimizing Primary Frequency Regulation Ability

Terminal Voltage Dynamics Analysis and Stability Assessment of Gird Forming Converters with the Impact of Grid Current Feedforward Control

Analysis of the Implication of Current Limits in Grid Forming Wind Farm

Stability Comparison Between Grid-forming and Grid-following Based Wind Farms Integrated MMC-HVDC

Grid‐forming converters in interconnected power systems: Requirements, testing aspects, and system impact

Impedance-based Analysis of Potential Stability Risk Between Grid-Forming and Grid-Following Wind Turbine Systems