Abstract:The diagram illustrates the power‐angle curves of grid‐forming (GFM) converters influenced by current thresholds. When the phase resides within the yellow area, the output current of the GFM is below its threshold, thereby exhibiting characteristics akin to those of a synchronous generator (depicted by the blue curve). Conversely, when positioned outside the yellow area, the output current of the GFM exceeds its threshold, manifesting complex nonlinear behavior (represented by the red curve). The inherent constraints of grid‐forming converters affect their ability to maintain voltage source characteristics within a specific operational range. In response to these limitations, ongoing pilot projects involving grid‐forming technology have adjusted their current thresholds up to three times the rated current, significantly exceeding the traditionally threshold of 1.2 times the rated current. This paper aims to investigate the effects of current thresholds on the dynamic responses of grid‐forming converters under large disturbances, with the intention of identifying an optimal current threshold that meets the grid's demands for maintaining voltage source characteristics and overall stability. A novel power angle relationship is introduced, integrating current limits and anti‐windup voltage controls into the equivalent circuit models of these converters. Analytical expressions for stable and unstable equilibrium points are derived, improving insights into the converters' dynamic behaviour and their resilience to phase jumps across various current thresholds and short‐circuit ratios. Findings indicate that higher current thresholds substantially improve phase jump limits and withstand capabilities. The paper concludes with proposed configurations and optimization strategies for current thresholds, all supported by experimental validation.

Analysis of the Implication of Current Limits in Grid Forming Wind Farm

Transient Stability Analysis and Coordination Control Design for Grid-Forming PMSG Based on Dynamics of DC-Link Capacitor

Effects of current limit for grid forming converters on transient stability: Analysis and solution

Grid-Forming Control for DFIG Based Wind Farms to Enhance the Stability of LCC-HVDC

Terminal Voltage Dynamics Analysis and Stability Assessment of Gird Forming Converters with the Impact of Grid Current Feedforward Control

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Grid-Forming Control Methods for Weakly Connected Offshore WPPs

Grid Forming Converters in Renewable Energy Sources Dominated Power Grid: Control Strategy, Stability, Application, and Challenges

Analysis of optimal grid-forming converter penetration in AC connected offshore wind farms

Extended Characteristics of Grid-Forming Control: Seen from the Perspective of AC Power Supply

Impedance-based Analysis of Potential Stability Risk Between Grid-Forming and Grid-Following Wind Turbine Systems

Transient Synchronization Stability Modeling and Analysis of Grid-Following Converter Considering Current Dynamics

Oscillations between Grid-Forming Converters in Weakly Connected Offshore WPPs

Grid-Forming Inverter-based Wind Turbine Generators: Comprehensive Review, Comparative Analysis, and Recommendations

Comparative assessment of typical controlrealizations of grid forming converters based ontheir voltage source behaviour

Frequency and Voltage Compliance Capabilities of Grid-Forming Wind Turbines in Offshore Wind Farms in Weak AC Grids

Investigating the effects of current thresholds on phase jump limits and withstand capabilities in grid‐forming converters

Improved Dynamic Response in Grid-Forming Converters with Current Limiting Control during Fault Conditions

Fault Handling Capabilities of Grid-Forming Wind Turbines in Offshore Wind Farms Connected With MMC HVDC System

Control strategy to improve power transmission capacity from wind farms to weak AC grids

Grid-Impedance-Based Transient Current Control for Offshore Wind Turbines under Low-Voltage Fault