Abstract:In the conventional finite control set model predictive torque control, the cost function consists of different control objectives with varying units of measurements. Due to presence of diverse variables in cost function, weighting factors are used to set the relative importance of these objectives. However, selection of these weighting factors in predictive control of electric drives and power converters still remains an open research challenge. Improper selection of weighting factors can lead to deterioration of the controller performance. This work proposes a novel weighting factor tuning method based on the Multi-Criteria-Decision-Making (MCDM) technique called the Entropy method. This technique has several advantages for multi-objective problem optimization. It provides a quantitive approach and incorporates uncertainties and adaptability to assess the relative importance of different criteria or objectives. This technique performs the online tuning of the weighting factor by forming a data set of the control objectives, i.e., electromagnetic torque and stator flux magnitude. After obtaining the error set of control variables, the objective matrix is normalized, and the entropy technique is applied to design the corresponding weights. An experimental setup based on the dSpace dS1104 controller is used to validate the effectiveness of the proposed method for a two-level, three-phase voltage source inverter (2L-3P) fed induction motor drive. The dynamic response of the proposed technique is compared with the previously proposed MCDM-based weighting factor tuning technique and conventional MPTC. The results reveal that the proposed method provides an improved dynamic response of the drive under changing operating conditions with a reduction of 28% in computational burden and 38% in total harmonic distortion, respectively.

Using Optimization Algorithms for Control of Multiple Output DC-DC Converters

A Digital Dual-Mode Lqr Optimal Controller for Boost Converter over A Wide Operation Range

Dual-Mode Lqr-Feedforward Optimal Control for Non-Minimum Phase Boost Converter

Optimal Weighting Factor Design of Finite Control Set Model Predictive Control Based on Multiobjective Ant Colony Optimization

Design and Analysis of an Optimal Controller for Parallel Multi-Inverter Systems

Wide-Load Range Multiobjective Efficiency Optimization Produces Closed-Form Control Solutions for Dual Active Bridge Converter

DC-DC Converters Optimization in Case of Large Variation in the Load

A Graphic Weighting Factor Design Method for Finite Control Set Model Predictive Control of Power Converters

Optimized PID Controller of DC-DC Buck Converter based on Archimedes Optimization Algorithm

A Robust Optimal Coordinated Droop Control Method for Multiple VSCs in AC–DC Distribution Network

Optimization of Adaptive Sliding Mode Controllers Using Customized Metaheuristics in DC-DC Buck-Boost Converters

Optimal Triple-Phase-shift Controller Design of Isolated Bidirectional DC-DC Converter Based on Ant Colony Algorithm and BP Neural Network

Optimal Multivariable Control for Wide Output Regulation and Full-Range Efficiency Optimization in LCC–LCC Compensated Wireless Power Transfer Systems

Optimized Control Method of Cascaded Bi-Directional DC-DC Converters

Optimal weighting factor design based on entropy technique in finite control set model predictive torque control for electric drive applications

A New Approach in Optimal Control of Step-Down Converters Based on a Switch-State Controller

Design of digital compensators for multi-output DC-DC converters with reduced cross-regulation

Integrated Optimization Control Strategy of DAB Based on DPS and Adaptive Genetic Algorithm

An Adaptive Controller Design using Duelist Optimization Algorithm for an Interconnected Power System

Output-Feedback Saturated Control of DC-DC Converters With Unknown Independent Loads

Refined sinh cosh optimizer tuned controller design for enhanced stability of automatic voltage regulation