Abstract:The development of sensitive fiber-optic accelerometers is a subject of continuing interest. To acquire high resolution, Michelson phase interferometric techniques are widely adopted. Among the variety structures, the compliant cylinder approach is particularly attractive due to its high sensitivity that is defined as the induced phase shift per applied acceleration. While the two arms of Michelson interferometer should be at the same optical path, it is inconvenient to adjust the two arms' length to equal, also the polarization instability and phase random drift will cause a signal decline. To overcome these limitations, a novel optical fiber accelerometer based on differential interferometric techniques is proposed and investigated. The interferometer is a Sagnac-like white light interferometer, which means the bandwidth of laser spectrum can be as wide as tens nanometers. This interferometer was firstly reported by Levin in 1990s. Lights are divided to two paths before entering the coupler. To induce time difference, one passes through a delay arm and another goes a direct arm. After modulated by the sensing component, they reflect to opposite arm. The sensing part is formed by a seismic mass that is held to only one compliant cylinder, where the single-mode optical fiber is wrapped tightly. When sticking to vibrations, the cylinder compresses or stretches as a spring. The corresponding changes in cylinder circumference lead to strain in the sensing fibers, which is detected as an optical phase shift by the interferometer. The lights from two arms reach the vibration source at different time, sensing a different accelerate speed; produce a different optic path difference. Integrating the dissimilarity of the accelerated speed by time can obtain the total acceleration graph. A shaker's vibration has been tested by the proposed accelerometer referring to a standard piezoelectric accelerometer. A 99.8% linearity of the optical phase shift to the ground acceleration is achieved. The acceleration sensitivity is 300 rad/g. It proves to have a simple structure, good practice, reliable measurement and stable performance.

The design of a new fiber optic sensor for measuring linear velocity with pico meter/second sensitivity based on Weak-value amplification

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

Amplification of rotation velocity using weak measurements in Sagnac's interferometer

High-Sensitivity Microfiber Strain and Force Sensors

The Strain Sensor with Enhanced Sensitivity Based on Improved Optical Fiber Michelson Interferometer

Experimental study on a parallel optical fiber Sagnac loops-based sensor with the advantages of both high sensitivity and ultra-wide measurement range

All-fiber heterodyne velocity and displacement interferometer based on DPLL Doppler tracking with sub-nanometer per second and picometer sensitivity

Ultrasensitive Measurement of Micronewton Force or Weak Dynamic Signal Based on PDMS Sealed Tapered Fiber Mach–Zehnder Interferometer

Ultrahigh-sensitivity optical fiber sensor based on the virtual harmonic vernier effect

New Scheme Of Sagnac Interferometric Fiber-Optic Current Sensor Insensible To Mechanical Vibration

Design Of Vibration-Insensitive Sagnac Fiber-Optic Current Sensors Using Spun High-Birefringence Fibers

Toward Ultra-high Sensitivity in Weak Value Amplification

High-sensitivity and Real-Time Displacement Sensor Based on Polarization Properties in Fiber

A Transverse Load Sensor with Ultra-Sensitivity Employing Vernier-Effect Improved Parallel-Structured Fiber-Optic Fabry-Perot Interferometer

Fiber-optic sensors based on Vernier effect

Sagnac interferometer-based optical fiber strain sensor with exceeding free spectral measurement range and high sensitivity

A Novel Differential Optical Fiber Accelerometer

Ultra-low noise phase measurement of fiber optic sensors via weak value amplification

Sensitivity amplification of fiber-optic in-line Mach–Zehnder Interferometer sensors with modified Vernier-effect

A Novel Linear Sagnac Interferometer in Position Determination of Perturbations

A novel compensation fiber coil for eliminating Sagnac Effect in fiber optic current sensor