Abstract:The control of material loss mechanisms is playing an increasingly important role for improving coherence times of superconducting quantum devices. Such material losses can be characterized through the measurement of planar superconducting resonators, which reflect losses through the resonance's quality factor $Q_l$. The resonance quality factor consists of both internal (material) losses as well as coupling losses when resonance photons escape back into the measurement circuit. The combined losses are then described as $Q_l^{-1} = \mathrm{Re}\{Q_c^{-1}\} + Q_i^{-1}$, where $Q_c$ and $Q_i$ reflect the coupling and internal quality factors of the resonator, respectively. To separate the relative contributions of $Q_i$ and $Q_c$ to $Q_l$, diameter-correcting circle fits use algebraic or geometric means to fit the resonance signal on the complex plane. However, such circle fits can produce varied results, so to address this issue, we use a combination of simulation and experiment to determine the reliability of a fitting algorithm across a wide range of quality factor values from $Q_i\ll Q_c$ to $Q_c\ll Q_i$. In addition, we develop a novel measurement protocol that can not only reduce fitting errors by factors $\gtrsim 2$ but also mitigates the influence of the measurement background on the fit results. This technique can be generalized for other resonance systems beyond superconducting resonators.

Retrieving Quality Factors for Reflection & Transmission Measurements

Research of Coupling Coefficient Extraction of a Cavity Resonator

Lossy Filter with Lniform Q-Factors by Optimization Method

Lossy filter with uniform Q-factors by optimization method

A Flat-Passband Microstrip Filter With Nonuniform- $Q$ Dual-Mode Resonators

Quality factor of a transmission line coupled coplanar waveguide resonator

On the Calculation of the Quality Factor in Contemporary Photonic Resonant Structures

Measurement of Resonant Frequency and Quality Factor of Microwave Resonators: Comparison of Methods

Comparing unloaded Q-factor of a high-Q dielectric resonator measured using the transmission mode and reflection mode methods involving S-parameter circle fitting

Space-contained conflict revision, for geographic information

Novel Method to Measure Unloaded Quality Factor of Resonant Cavities at Room Temperature

Circle fit optimization for resonator quality factor measurements: point redistribution for maximal accuracy

A highly accurate measurement of resonator $Q$-factor and resonance frequency

Diffractive Broadband Coupling into High-Q Resonant Cavities

A Precise Measurement of Quality Factor for Planar Microtoroid Resonators

A General Characterizing Method for Ring Resonators Based on Low Coherence Measurement

Measurement for complex permittivity and complex permeability of film

Interplay of coupling, residual, and quasiparticle losses for the frequency- and temperature-dependent quality factor of superconducting resonators

A method of measuring equivalent parameters of quartz crystal resonators

New method to measure the unloaded quality factor of superconducting cavities

Transmission, S-matrix, and Partial Densities of States for Ac Transport Through a Resonant Cavity with Multileads