Abstract:In the ultra‐high frequency (UHF) technique, the partial discharge inside the power transformer can be localized by the hyperbolic equations. This method is sensitive to the time difference of arrival (TDOA) between the sensors because a small error in the TDOA vector may introduce a considerable localization error. This sensitivity depends on where the UHF sensors are installed on the transformer tank. By properly positioning the UHF sensors on the tank, this sensitivity is reduced. This paper presents a new method to find the best places on the transformer tank for installing the UHF sensors in such a way that the errors in the TDOA vector have the least effect on the localization accuracy. This paper proposes a new method for improving the partial discharge (PD) localization accuracy by detecting the best places of ultra‐high frequency (UHF) sensors on the power transformer tank. In this way, firstly, the critical sites inside the power transformer that can produce PD are determined. Then the sensors' positioning is done in such a way that if the PD happens at each point of these critical sites, the distance between the estimated PD location obtained by solving the time difference of arrival (TDOA) equations and the actual PD location is laid in an acceptable range. For this purpose, the TDOA equations are linearized around the critical PD coordinates as a matrix form A.X = B. The configuration of the sensor positions that minimizes the condition number of the matrix A is the best configuration. To evaluate the effectiveness of the proposed method, several simulations and evaluations are performed on a power transformer in the CST software. The obtained results and comparing them with the previous method and also conventional arbitrary sensors positioning confirm the effectiveness of this method.

Detection of Transformer Winding Axial Displacement by Kirchhoff and Delay and sum Radar Imaging Algorithms

Detection of Winding Axial Deformation in Power Transformers by UWB Radar Imaging

GLRT-Based Mitigation of Partial Discharge Effect on Detection of Radial Deformation of Transformer HV Winding Using SAR Imaging Method

Detection of Inter-Turn Short Circuit Fault for Dual Three-Phase PMSM Based on Vector Space Decomposition Scheme

Design and implementation of dielectric windows for detection of radial deformation of HV transformer winding using radar imaging

Analysis Of Transformer'S Winding Vibration Characteristics Using Hilbert-Huang Transform

Detection of Winding Deformation Based on the Vibration Phase Difference Between Multiple Sensors of Transformers

Method for detecting system on power transformer winding deformation

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers

Diagnostic Research for the Failure of Electrical Transformer Winding Based on Digital Twin Technology

Transformer Winding Fault Detection by Vibration Analysis Methods

Field test on a transformer for partial discharge location by uwb-rf method

Partial discharge localisation in transformers using UHF technique: non-iterative method

Fault Identification of Winding Axial Displacement and Inter-turn Short Circuit for UHVDC Transformer

Research on new method of transformer winding deformation detection

Radial Deformation Emplacement in Power Transformers Using Long Short-Term Memory Networks

Classification and Discrimination Among Winding Mechanical Defects, Internal and External Electrical Faults, and Inrush Current of Transformer

Ultra‐high frequency sensors positioning on the power transformer to mitigate the negative effects on the partial discharge localization accuracy

Kirchhoff Migration Method for Tube Detection with UWB GPR

Study on the Ultra-High-frequency Sensors for PD Detection in Power Transformer