Abstract:Polycrystalline ZnS films were prepared by pulsed laser deposition (PLD) on quartz glass substrates under different growth conditions at different substrate temperatures of 20, 200, 400, and 600 C, which is a suitable alternative to chemical bath deposited (CBD) CdS as a buffer layer in Cu(In,Ga)Se2 (CIGS) solar cells. X-ray diffraction studies indicate the films are polycrystalline with zinc-blende structure and they exhibit preferential orientation along the cubic phase -ZnS (111) direction, which conflicts with the conclusion of wurtzite structure by Murali that the ZnS films deposited by pulse plating technique was polycrystalline with wurtzite structure. The Raman spectra of grown films show A1 mode at approximately 350 cm1, generally observed in the cubic phase -ZnS compounds. The planar and the cross-sectional morphology were observed by scanning electron microscopic. The dense, smooth, uniform grains are formed on the quartz glass substrates through PLD technique. The grain size of ZnS deposited by PLD is much smaller than that of CdS by conventional CBD method, which is analyzed as the main reason of detrimental cell performance. The composition of the ZnS films was also measured by X-ray fluorescence. The typical ZnS films obtained in this work are near stoichiometric and only a small amount of S-rich. The energy band gaps at different temperatures were obtained by absorption spectroscopy measurement, which increases from 3.2 eV to 3.7 eV with the increasing of the deposition temperature. ZnS has a wider energy band gap than CdS (2.4 eV), which can enhance the blue response of the photovoltaic cells. These results show the high-quality of these substitute buffer layer materials are prepared through an all-dry technology, which can be used in the manufacture of CIGS thin film solar cells.

[Preparation and transmissivity of ZnS nanocolumn thin films with glancing angle deposition technology]

The growth of nanoscale ZnO films by pulsed-spray evaporation chemical vapor deposition and their structural, electric and optical properties

Synthesis of Two-Dimensional Micron-Sized Single-Crystalline ZnS Thin Nanosheets and Their Photoluminescence Properties

Surface Morphology, Electrochemical and Electrical Performances of ZnO Thin Films Sensitized with Ag Nanoparticles by UV Irradiation

Transparent Nanostructured ZnS films by Low Temperature Sputtering for Flexbile Optoelectronic Devices

[Influence of Parameters of ZnS Film on the Organic/inorganic Composite Luminescence Devices].

Growth Behavior of Nanocrystalline ZnS Thin Films for Solar Cell Using CBD Technique

Nanocrystalline ZnS thin films by chemical bath deposition method and its characterization

Zns/Ag/Zns Nano-Multilayer Films for Transparent Electrodes in Flat Display Application

Zns/Si Composite Nano-Structured Thin Films and Their Photoluminescence

Tailoring the structural, optical, and optoelectrical properties of innovative n-type Ag2ZnSnS4 thin films and investigating ITO/Ag2ZnSnS4/SnS/Au heterojunction

Structural, morphological, and optical bandgap properties of ZnS thin films: a case study on thickness dependence

Pulsed Laser Deposition Zns Buffer Layers for Cigs Solar Cells

Influences of Substrate and Annealing on the Structural and Optical Properties and Photoluminescence of Nanocrystalline Zno Films Prepared by Plasma Assisted Pulsed Laser Deposition

Preparation and Protection of ZnS Surface Sub-Wavelength Structure for Infrared Window

ZnS nanostructured thin-films deposited by successive ionic layer adsorption and reaction

Cathodoluminescence Modulation Of Zns Nanostructures By Morphology, Doping, And Temperature

Superior Texture-Controlled Zno Thin Film Using Electrochemical Deposition

Large-scale synthesis of ZnS nanosheets by the evaporation of ZnS nanopowders

Effect of complexing agent and annealing atmosphere on properties of nanocrystalline ZnS thin films

Influence of different pH regulators and pH values on optical properties of ZnS nanocrystalline thin films