Abstract:IntroductionMRI has been increasingly used in radiation therapy to facilitate tumor and organ delineation and assess treatment response. Diffusion MRI can provide cellularity information and may enable functional‐based treatment planning and adaptation. However, strong distortion associated with the conventional diffusion‐weighted single‐shot echo‐planar imaging (DW‐ssEPI) sequence is problematic for accurate target delineation. The goal of this work is to propose a 3D diffusion sequence with minimal distortion for radiation therapy applications.MethodsA 3D diffusion‐prepared magnitude‐stabilized balanced steady‐state free precession sequence (DP‐MS‐bSSFP) was developed. A 2D navigator was acquired during the linear catalyzation stage of the bSSFP readout to estimate the phase, which was then used in a plane‐by‐plane low‐rank constrained reconstruction to correct the shot‐to‐shot k‐space inconsistency. A diffusion phantom was scanned to evaluate and compare the geometric reliability and apparent diffusion coefficient (ADC) accuracy with the conventional DW‐ssEPI. Eight landmarks were selected on each slice of the images to calculate the target registration error (TRE), which was used as a surrogate for geometric fidelity. The phantom was scanned under both 0℃ and room temperature. Brain scans were performed on five healthy volunteers. In the first volunteer, protocols of 1, 2, and 4 shots per Kz plane were compared. In vivo geometric fidelity and ADC accuracy were evaluated on the remaining four volunteers using the protocol of four shots per Kz plane. In the geometric fidelity study, 8–10 landmarks were picked on each slice to calculate the TRE. Regions of interest were placed on the white matter, the cerebellum, and the cerebrospinal fluid region to evaluate the ADC agreement between DW‐ssEPI and DP‐MS using the Bland‐Altman plot. All scans were performed at 1.5 mm isotropic resolution to meet the high‐resolution requirement of many radiotherapy applications.ResultsThe DP‐MS had drastically improved geometric accuracy compared with DW‐ssEPI on the phantom. The mean TRE decreased from 2.09 mm to 0.70 mm. The percentage difference of the ADC values between the two diffusion sequences were less than 5.5% and 7% for the 0℃ and room temperature study, respectively. The DW‐ssEPI had strong distortion and susceptibility‐related artifacts at tissue air boundary, whereas distortion was minimal in DP‐MS images. Overall, the mean/max TRE was over 2 mm/7 mm in the volunteers for DW‐ssEPI, whereas less than 0.8 mm/2 mm for DP‐MS. Good ADC agreement was observed for the white matter, the cerebellum, and the CSF based on the Bland‐Altman plots.ConclusionA 3D diffusion sequence was developed and validated. It provided high‐resolution diffusion imaging with mean distortion less than 1 mm at 1.5 T, and is a promising imaging technique for treatment planning and adaptive radiotherapy.

T1234: A distortion-matched structural scan solution to misregistration of high resolution fMRI data

3D-EPI Blip-Up/Down Acquisition (BUDA) with CAIPI and Joint Hankel Structured Low-Rank Reconstruction for Rapid Distortion-Free High-Resolution T2* Mapping

3D-CAIPI-BUDA and Joint Hankel Low-Rank Reconstruction Enable Rapid and Distortion-free High-Resolution T2* Mapping and QSM

3D Isotropic Resolution Diffusion-Prepared Magnitude-Stabilized Bssfp Imaging with High Geometric Fidelity at 1.5 Tesla

Three-dimensional Simultaneous Brain Mapping of T1, T2, T2*and Magnetic Susceptibility with MR Multitasking

The Simultaneous Measurement of Reversed Phase-Encoding EPI in a Single fMRI Session at 7T: Quantitative and Qualitative Evaluation of Geometric Distortion Correction in Submillimetre fMRI

T2-BUDA-gSlider: Rapid High Isotropic Resolution T2 Mapping with Blip-Up/down Acquisition, Generalized SLIce Dithered Enhanced Resolution and Subspace Reconstruction

Efficient T-2 Mapping with Blip-Up/down EPI and Gslider-Sms (T-2-buda-gslider)

Image Distortion Correction in fMRI: A Quantitative Evaluation

Framewise multi-echo distortion correction for superior functional MRI

Sampling strategies and integrated reconstruction for reducing distortion and boundary slice aliasing in high‐resolution 3D diffusion MRI

High Spatial-Resolution and Acquisition-Efficiency Cardiac MR T1 Mapping Based on Radial bSSFP and a Low-Rank Tensor Constraint

Three-dimensional simultaneous brain T 1 , T 2 , and ADC mapping with MR Multitasking.

Rapid high-resolution T1 mapping using a highly accelerated radial steady-state free-precession technique

SynBOLD-DisCo: Synthetic BOLD images for distortion correction of fMRI without additional calibration scans

Reconstruction for 7T High‐resolution Whole‐brain Diffusion MRI Using Two‐stage N/2 Ghost Correction and L1‐SPIRiT Without Single‐band Reference

Submillimeter diffusion MRI using an in-plane segmented 3D multi-slab acquisition and denoiser-regularized reconstruction

Tailored magnetic resonance fingerprinting

Optimized protocol for high resolution functional magnetic resonance imaging at 3T using single-shot echo planar imaging

Rapid three-dimensional multiparametric MRI with quantitative transient-state imaging